Husqvarna CTH180 XP User Manual

025

91

Adjust seat before tightening adjustment knob.
•     Remove adjustment knob and fl at washer securing 

seat to cardboard packing and set aside for assembly 
of seat to tractor.

•         Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•    Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•      Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•      Pivot seat and pan forward and assemble adjustment 

knob and fl at washer loosely. Do not tighten.

•      Lower seat into operating position and sit on seat.
•     Slide seat until a comfortable position is reached 

which allows you to press clutch/brake pedal all the 
way down.

•      Get off seat without moving its ad just ed position.
•      Raise seat and tighten adjustment knob securely.

•      Press lift lever plunger and raise attachment lift lever 

to its highest po si tion.

•      Release  parking  brake  by  de press ing clutch/brake 

ped al.

•     Place freewheel control in "trans mis sion dis en gaged 

position" (See “TO TRANS 

PORT” in the Op 

er a tion 

section of this manual).

•      Roll tractor forward off skid.
•        Remove banding holding the defl ector shield up against 

tractor.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other peo ple and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•     Place freewheel control in "trans 

mis sion en 

gaged" 

po si tion (see "TO TRANSPORT" in Op er a tion section 
of this manual).

•      Sit on seat in operating position, depress clutch/brake 

pedal and set the parking brake.

•      Place motion control lever in neutral (N) position.

NOTE: You may now roll or drive your tractor off the skid. 
Follow the appropriate instruction below to remove the 
tractor from the skid.

2466

02464

•      Replace battery cover.

Open battery cover for:
•     Inspection for secure connections (to tighten hard-

ware).

•      Inspection for corrosion.
•      Testing battery.
•      Jumping (if required).
•      Periodic charging .