Husqvarna PZ6029D User Manual
OPeRaTION
30
Turn the key to the RUN position and wait for the
8.
glow plug light to go out. Press in and turn the
ignition key to the START position.
If the engine fails to start after 10 seconds, the
engine will stop cranking and the ignition switch
must be turned off to reset the start sequence.
When the engine starts, immediately release the
ignition key back to the run position.
NoTE: The fan will power up thirty seconds
after the ignition is turned on and will blow air
through the radiator to help clean debris from
the radiator and debris screen. The fan will then
reverse and continue in suction until the ignition
is turned off.
ignition key to the START position.
If the engine fails to start after 10 seconds, the
engine will stop cranking and the ignition switch
must be turned off to reset the start sequence.
When the engine starts, immediately release the
ignition key back to the run position.
NoTE: The fan will power up thirty seconds
after the ignition is turned on and will blow air
through the radiator to help clean debris from
the radiator and debris screen. The fan will then
reverse and continue in suction until the ignition
is turned off.
Move the throttle to the middle position.
7.
Move the steering controls outward to the
6.
locked (outer) neutral position.
8065-071
Set the throttle
8065-018
Place controls in neutral position
8065-071
Turn the key to RUN and observe glow plug light