Husqvarna LTH1536 User Manual

NOTE: You may now roll or drive your tractor off the skid. 
Follow the ap pro pri ate instruction below to remove the 
tractor from the skid

.

•      Press lift lever plunger and raise attachment lift lever 

to its highest po si tion.

•      Release  parking  brake  by  de press ing clutch/brake 

ped al.

•     Place freewheel control in "trans mis sion dis en gaged 

position" (See “TO TRANS 

PORT” in the Op 

er a tion 

section of this manual).

•      Roll tractor forward off skid.
•         Remove banding holding the defl ector shield up against 

tractor.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other peo ple and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•     Place freewheel control in "trans 

mis sion en 

gaged" 

po si tion (see "TO TRANSPORT" in Op er a tion section 
of this manual).

•      Sit on seat in operating position, depress clutch/brake 

pedal and set the parking brake.

•      Place motion control lever in neutral (N) position.
•      Press lift lever plunger and raise attachment lift lever 

to its highest position.

•         Start the engine. After engine has started, move throttle 

control to idle position.

•      Release parking brake.
•      Slowly move the mo tion control lever for ward and slowly 

drive tractor off skid.

•      Apply brake to stop trac tor, set park ing brake and place 

motion con trol lever in neutral po si tion.

•      Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.

02466

02464

02602

•      Lift seat pan to raised position.
•      Remove terminal protective caps and discard.
•      If this battery is put into service after month and year 

indicated on label (label located between terminals) 
charge battery for minimum of one hour at 6-10 amps. 
(See "BATTERY" in the Maintenance section of this 
manual for charg ing in struc tions).

•         First connect RED battery cable to positive (+) terminal 

with hex bolt and keps nut as shown.  Tighten securely. 
Slide terminal cover over terminal.

•     Connect BLACK grounding cable to negative (-) ter-

minal with remaining hex bolt and keps nut.  Tighten 
securely. 

02604