Husqvarna 03002 User Manual

Your new tractor has been assembled at the factory with ex-

ception of those parts left unassembled for shipping purposes.  

•  Lift hood to raised position.
NOTE: If this battery is put into service after month and 

year indicated on label (label is located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging instructions).
•  For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments" 

section in this manual.

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.
(2)  7/16" wrenches 

 

Utility knife

(1)  1/2" wrench  

 

Tire pressure gauge

(1) 

3/4" 

wrench 

  Pliers

(1)  3/4" socket w/drive ratchet 

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

•  Remove all accessible loose parts and parts cartons  

from carton .

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Remove mower and packing materials.
•  Check for any additional loose parts or cartons and 

remove.

(2) Keys

(1) Wheel 

(5)  Large Retainer 
 

Springs - 7/16

(2)  Smaller Retainer 
 

Springs - 5/16

(1) Locknut  

3/8-16 

(1) Oil Drain Tube 
For Future Use

(1) Shoulder Bolt

(1) Anti-Sway Bar

(1) 3/4 O.D. Washers 

(1) 1-1/4 O.D. Washer

(3) 1-3/16 O.D. Washers 

(2) Rear Lift Link

Assemblies