Cal Spas LTR20101000 User Manual

Page of 60
2010 Portable Spa
LTR20101000, Rev. C
Operating 
Your Spa
www.calspas.com
12
Operating Your Spa
5100, 6200 and 6300 Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.
6200 and 6300 Control Panel
Initial Start up
When first powered up, your spa will perform a self-
diagnostic  check  and  go  into  priming  mode.  The 
topside will display PR to indicate this. Priming mode 
will be active for less than five minutes.
Sometimes the pump fails to prime, especially when 
spa  owners  do  not  fill  their  spas  through  the  filter 
canister. You can avoid priming problems by following 
these steps during priming mode. 
Press the JETS button to turn on the pump and 
1. 
let  it  run  for  10  seconds.  The  pump  should  be 
running in low speed.
Press  the  JETS  buttons  again  and  let  the  pump 
2. 
run in high speed for 10 seconds.
Press the JETS button again to turn off the pump. 
3. 
The pump should be left in the off position for 10 
to 15 seconds.
Repeat  steps  1  through  3  until  water  is  flowing 
4. 
through all the jets and all air is removed from the 
plumbing.
When the spa has finished priming, the heater will be 
activated and the water temperature will be maintained 
in standard mode.  The spa will heat to 100°F (37.5°C) 
at  start  up  until  the  set  temperature  is  changed  as 
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water 
temperature  in  degrees  Fahrenheit.  The  displayed 
temperature will only be current after the pump has 
been running for at least two minutes.
To display the temperature that the spa is set to:
Press the 
• 
Temp button. The temperature setting 
will flash.
While the display is flashing, each time you press 
• 
Temp button, the set temperature will change up 
or down one degree.
If  the  desired  temperature  is  opposite  of  the 
• 
direction  each  press  of  the  button  is  making, 
release button, allow display to stop flashing and 
then press Temp button to change temperature 
the other direction. 
5100 Control Panel (one and two pump systems)