Invacare 3800 User Manual
SECTION 3—OPERATION
26
Operating Shower/Massage Wand
NOTE: For this procedure, refer to FIGURE 3.3.
NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.
1. Turn shower/massage wand on to desired flow by rotating shower On/Off valve
(Detail “A”).
2. Adjust water temperature using the water temperature valve while watching the flow
water thermometer (Detail “B”).
3. Adjust shower spray by rotating shower wand head (Detail “C”).
NOTE: Refer to following chart for shower head adjustment settings.
4. Turn shower On/Off valve to off position when finished.
FIGURE 3.3 Operating Shower/Massage Wand
Filling Tub
NOTE: For this procedure, refer to FIGURE 3.4 on page 27.
1. Close the drain (Detail “A”).
2. Turn tub fill On/Off valve to On position by rotating valve (Detail “B”).
3. Adjust water temperature using the water temperature valve while watching flow
water thermometer (Detail “C”).
4. Turn tub fill on/off valve to off position when water reaches desired level (Detail “B”).
NOTE: If hydromassage use is anticipated, water level MUST be completely above the whirlpool jets
(Detail “A”).
(Detail “A”).
Stream
Shower Spray
Mixture of Spray and Pulse Massage
Pulse Massage
Water Temperature Valve
Flow Water
Thermometer
Shower On/Off Valve
Shower/Massage
Wand
Head
DETAIL “C”
DETAIL “B”
DETAIL “A”