Toro 4042 User Manual

Greensmaster eFlex1800/2100

Page 5 -- 4

Chassis and Controls

Service and Repairs

Handle Assembly

Figure 2

1. Brake lever

2. Brake cable

3. Handle

4. Reel clutch cable

5. Traction and reel drive lever

6. Throttle assembly

7. Console cover

8. Washer head screw (4 used)

RIGHT

FRONT

Handle Removal (Fig. 2)

1. Park machine on level surface. Turn key switch to the

OFF position and remove key from the switch. Discon-

nect the battery pack (see Battery Pack Connection in

the General Information section).

2. Remove console cover from handle assembly.

3. Disconnect reel clutch and brake cables from trans-

mission (see Cable Replacement in this section).

4. Label all wire harness connections for assembly pur-

poses. Disconnect wire harness connections from elec-

trical components on handle. Position wire harness

away from handle.

5. Note height adjustment of handle for assembly pur-

poses.

6. Support handle assembly to prevent it from moving.

NOTE: The offset handle clamps on eFlex 2100 ma-

chines are mounted on the outside of the side plates

(Fig. 3). On eFlex 1800 machines, the offset handle

clamps are mounted on the inside of the side plates (Fig.

4).