Husqvarna 323E User Manual

English –

Assembling the blade

ASSEMBLY

Fit the blade as follows:

1. Fit the drive disc (A) on

the outgoing shaft. Make
sure that the edge that fi ts
in the hole of the blade is
facing outward.

2. Block the blade rotation

by inserting locking pin in
the hole behind the blade
guard engaging it in the
corresponding hole in the
drive disc.

3. Fit the blade (B) on the

drive disc.

4. Fit

the

support

fl ange (C). The support
fl ange must be fi tted with
its outer edge hard up
against the blade.

5. Fit the locknut (D). NOTE!

The locknut has left-hand
threads. The tightening
torque of the locknut is 35
– 50 Nm.

6. Remove the locking pin.

Assembling the loop handlebar

NOTE! Do not forget to remove the locking pin before using
the machine.

WARNING!
Under no circumstances may the edge cutter
blade be used without the blade guard fi tted.

Assembling the angle gear

• Assemble the angle gear

back on the supporting tube.

Turn the blade so that the

drive shaft engages in the
angle gear.

• Position the angle gear so

that its slot is aligned with the
line on the supporting tube.

• Firmly tighten the screw.

• Position the handle on the

shaft. Note that the handle
must be mounted below the
arrow on the shaft.

• Fit the bolt, securing plate

and wing nut as shown in the
diagram.

• Tighten the wing nut.