Nilfisk Alto C 110.2 X-TRA User Manual

9

An ordinary 1/2" garden hose of 
min. 10 m and max. 25 m will 
be suitable.

NOTE: Connection to the public 
mains  according to regulations.

IMPORTANT! Only use wa-
ter without any impurities. If 
there is a risk of running sands 
in the inlet water (i.e. from 
your own well), an additional 
fi lter (106411231) should be 
mounted.

1. Let the water run through the 

water hose before connecting 
it to the machine to prevent 
sand and dirt from penetrat-
ing the machine.

  Note: Check that the fi lter is 

fi tted in the water inlet pipe 
and that it is not clogged up.

2. Connect the water hose to 

the water supply by means 
of the quick connector (inlet 
water, max. pressure: 10 bar, 
max. temperature: 40°C).

3. Turn on the water.

Do not cover the machine 
 during operation or use it in a 
room without adequate ventila-
tion ! 

Note: If the ma-
chine is left or not 
used for 5 min-

utes, it must be switched off on 
the start/stop switch "O" (1):

1. Press the start/stop switch 

"O".

2. Disconnect the electrical plug 

from the socket.

3. Shut off the water supply and 

activate the trigger to relieve 
the machine of pressure.

4. Lock the spray gun (7a).

When releasing the trigger of 
the spray gun, the machine 
automatically stops. The ma-
chine will start again when you 
re- activate the spray gun.

The spray lance is affected 
by a thrust during operation 
- therefore always hold it fi rmly 
with both hands. IMPORTANT: 
Point the nozzle at the 
ground.

1. Check that the machine is in 

uprigth position.

Do not place the ma-

chine in high grass!

2. Release the trigger lock (7a).
3. Activate the trigger of the 

spray gun and let the water 
run until all air has escaped 
from the water hose.

4.  Press the Start/stop switch 

"I" (1).

5. Activate the trigger of the 

spray gun.

Always adjust the distance and 
thus the pressure of the nozzle 
to the surface, which is to be 
cleaned.