Casablanca Fan Company C16G73T User Manual

Step 2a. Hold the canopy bracket up to the ceiling with the ‘lip’ side 
facing the fl oor. Use a pen or pencil to mark screw placement through 
the holes in the bracket. 

Step 2b. Insert three black rubber grommets to the canopy bracket as 
shown. The bracket is then installed facing the ceiling. 

Step 2c. Drill holes on both sides of canopy bracket for even support. 
Select the set of screws most appropriate for your installation. 

Step2d.  Use one of the following screw combinations:

A. Wood screws and washers

B. Long wood screws and washers

C. Sheetrock anchors

Install screws and washers through the holes in the canopy bracket. 
Tighten screws until they are secure against the ceiling. 

Install sheetrock anchors through the holes in the canopy bracket. 
Tighten anchors until they are secure against the ceiling. 

Step 3a. Slide the hanging bracket support ring on to 
the downrod. Then, slide the downrod cover over the 
downrod. The base of the downrod should sit securely on 
the rubber gasket inside the downrod cover. 

Step 3b. Place the downrod (with the downrod cover 
attached) inside the canopy cover. The edge of the 
downrod cover should sit securely on the rubber gasket 
inside the canopy cover. 

PARTS NEEDED FOR THIS SECTION:

PARTS NEEDED FOR THIS SECTION:

CANOPY BRACKET HARDWARE (not to scale)

CANOPY COVER HARDWARE (not to scale)