Hampton Bay 68-ATR User Manual

6.

Setting the Code

This unit has 16 different code combinations.

To set the code, perform the following steps:

A. Setting the code on the transmitter:

a. Remove the battery cover. Press firmly

below arrow and slide battery cover off.

b. Slide code switches to your choice of up

or down position. (Factory setting is all up).

B. Setting the code on the receiver.

a. Slide code switches to the same position

as set on your transmitter.

b. Replace battery cover on transmitter.

C. Setting the light function on the transmitter.

a. Push the black switch to the left for “No

Dimmer” function.

b. Push the black switch to the right for

“Dimmer” function.
CAUTION:

Ceiling angle shall not exceed 30 degrees.
Controller Model: FAN28R-240W

EACH WIRE NUT (WIRE CONNECTOR) SUP-

PLIED WITH THIS FAN IS DESIGNED TO ACCEPT

UP TO ONE 12 GAUGE HOUSE WIRE AND TWO

WIRES FROM THIS FAN. IF YOU HAVE LARGER

THAN 12 GAUGE HOUSE WIRING OR MORE

THAN ONE HOUSE WIRE TO CONNECT TO THE

FAN WIRING, CONSULT AND ELECTRICIAN FOR

THE PROPER SIZE WIRE NUTS TO USE.

THE FREQUENCIES ON YOUR RECEIVER AND

TRANSMITTER HAVE BEEN PRESET AT THE

FACTORY. BEFORE INSTALLING THE RECEIV-

ER, MAKE SURE THE DIP SWITCHES ON THE

RECEIVER AND TRANSMITTER ARE SET TO

THE SAME FREQUENCY. THE DIP SWITCHES

ON THE TRANSMITTER ARE LOCATED INSIDE

THE BATTERY COMPARTMENT.

Finishing the Fan

Installation

STANDARD CEILING MOUNTING

Align the locking slots of the ceiling canopy

1.

with the two screws in the mounting plate.

Push up to engage the slots and turn clock-

wise to lock in place. Immediately tighten

the two mounting screws firmly.

Install the remaining two mounting

2.

screws into the holes in the canopy and

tighten firmly.

Install the decorative canopy ring by

3.

aligning the ring’s slots with the screws

in the canopy. Rotate the ring counter-

clockwise to lock in place.

You may now proceed to attaching the

4.

fan blades.

WHEN USING THE STANDARD BALL/DOWNROD

MOUNTING, THE TAB IN THE RING AT THE BOT-

TOM OF THE MOUNTING PLATE MUST REST IN

THE GROOVE OF THE HANGER BALL. FAILURE

TO PROPERLY SEAT THE TAB IN THE GROOVE

COULD CAUSE DAMAGE TO WIRING.

Figure 9