Roberts Gorden 75 User Manual

1 of 47

Your Safety is Important to Us!
This symbol is used throughout 
the manual to notify you of 
possible fire, electrical or burn 
hazards. Please pay special 
attention when reading and 
following the warnings in these 
sections.
Installation, service and, at a 

minimum, annual inspection of heater must be done 
by a contractor qualified in the installation and 
service of gas-fired heating equipment.
Read this manual carefully before installation, 
operation or service of this equipment.
Heaters are not approved for residential 
installations. These instructions, the layout drawing, 
local codes and ordinances and applicable 
standards that apply to gas piping, electrical wiring, 
venting, etc. must be thoroughly understood before 
proceeding with the installation.
Protective gear is to be worn during installation, 
operation and service. Thin sheet metal parts, 
including the various venting components, have 
sharp edges. To prevent injury, the use of work 
gloves is recommended. 

Before installation, check that the local distribution 
conditions, nature of gas and pressure and 
adjustment of the appliance are compatible.

This heater must be applied and operated under the 
general concepts of reasonable use and installed 
using the best building practices.
This appliance is not intended for use by persons 
(including children) with reduced physical, sensory 
or mental capabilities, or lack of experience and 
knowledge, unless they have been given 
supervision or instruction concerning use of the 
appliance by a person responsible for their safety. 
Children should be supervised to ensure that they 
do not play with the appliance.
For additional copies of the Installation, Operation 
and Service Manual, please contact Roberts-
Gordon LLC.

To prevent personal injury and damage to the 
heater, two persons will be required for installation.

Product safety signs or labels should be replaced by 
the product user when they are no longer legible. 
Please contact Roberts-Gordon LLC or your 
ROBERTS GORDON

®

 independent distributor to 

obtain replacement signs or labels. 

Figure 1 through Page 3, Figure 2.

In accordance with California Proposition 65 
requirements, a warning label must be placed in a 
highly visible location on the outside of the 
equipment (i.e. near equipment's serial plate). See 
label placement drawing 

on Page 2, Figure 1 

through Page 3, Figure 2 for label location. Avoid 
placing label on areas with extreme heat, cold, 
corrosive chemicals or other elements. To order 
additional labels, please contact Roberts-Gordon 
LLC or your ROBERTS GORDON

®

 independent 

distributor.