Ridgid 3068-OS User Manual

Page of 4
For Models 2048-OS and 204830-OS:
•  Do NOT put fuels, flammables, explosives or hazardous 
materials inside these products.
•  Gasoline,  solvents,  gun  powder  or  other  munitions, 
dynamite,  propane,  acetylene  or  other  such  products 
can explode if stored inside these products.
•  Use  these  products  ONLY  for  storing  and  transporting 
electric or hand tools and equipment, and other similar 
materials.
•  Failure  to  follow  these  warnings  or  modifications  or 
other uses of these products could result in death, seri-
ous injury or property damage.
OPERATORS MANUAL
MODELS 2032-OS, 2048-OS, 204830-OS, 3068-OS
RIDGID ON-SITE STORAGE EQUIPMENT
DANGER
–NOTICE–
 
 
 
 
Keep hands clear when closing lid. Failure to do so could result in severe injury.
WARNING
Read and understand all instructions and warnings before operating or using this product. 
–ATTENTION–
To  prevent  electric  shock,  explosion,  fire  and/or  serious 
personal injury when using storage chest with:
Extension Cord -
•  Follow all Extension Cord manufacturer’s Warnings and 
Instructions.
•  After  removing  knock-out,  insert  Rapid  Pass™  rubber 
grommet.    Do  NOT  insert  extension  cord  through  hole 
without grommet in place (see figure 8, on page 3).  
•  Only use a three-wire extension cord with all three prongs 
intact.  Never remove the round grounding prong.
•  Extension  cord  must  be  connected  to  a  120  Volt  GFCI 
protected outlet with proper ground.  If GFCI outlet is not 
available,  use  an  extension  cord  with  GFCI  protection 
built in.
•  Check the insulation and plugs of extension cord before 
using.  Do NOT use cord if it is worn or damaged.
•  Do NOT overload extension cord.
•  Remove  extension  cord  from  the  Rapid  Pass™  hole 
before moving or transporting storage chest.
•  Only  use  an  extension  cord  that  is  rated  for  outdoor 
use.
•  Do NOT connect extension cord to outlet that also sup-
plies critical safety equipment with power.
Cordless Power Tool Battery Chargers -
•  See Charger’s Owner’s Manual for proper use and care 
of charger and batteries.  Follow all Warnings and
  Instructions provided with your battery charger.
•  Place chargers and electrical connections in tray.
•  Chargers are Dry location use only.  Do NOT expose to 
liquid, vapor, or rain.  Should your charger become wet, 
Do  NOT  attempt  to  use.    Unplug  extension  cord  from 
supply before handling wet charger or cords.
•  Only use chargers and batteries that are intact and oper-
ating properly.
•  Do NOT touch metal prongs when plugging charger into 
extension cord.
•  Keep flammable materials like paper or rags away from 
charger, cords or connections.
•  Do NOT place or attempt to charge lead acid, car type 
batteries in storage chest.
WARNING
Any  modification  or  unintended  use  of  this  product 
shall  immediately  void  all  manufacturers  warranties. 
Manufacturer disclaims all liability for injuries to persons or 
property resulting from any modification to, or unintended 
use of this product.