Husqvarna 70 PP User Manual

ASSEMBLY

Remove the spreader and

components from carton and
place hopper up-side down on
a padded surface as shown.
Insert ends of leg into handle
brace as shown and align
holes. Attach brace and leg to
frame using (4) 1/4-20 x 2 1/4”
hex bolts and locknuts.

Turn spreader upright on

wheels. Insert screen into
hopper sliding it under the
screen clips. Attach the upper
handle assembly to handle
brace with the handle lever
brackets facing as shown.
Secure with (4) 1/4-20 x 1 1/2”
hex bolts and locknuts.

5/32 Dia. x

1 1/4” Cotter

Pin

3/16 Dia. x

2” Cotter Pin

Drive Wheel

Free Turning

Wheel

Handle

Brace

Leg

1/4-20 X 2”

Hex Bolt

1/4-20

LOCKNUT

Slide handle lever between

handle brackets as shown and
secure with (1) 1/4 dia. clevis pin and
3/32” dia. cotter pin. Make sure lever
pivots freely. Install handle grips
onto upper handle.

Soapy water

will ease installation. (Do not use
petroleum based products).

NOTE POSITION OF
LEVER BRACKETS

Upper Handle

Assembly

Screen

Screen Clip

1/4-20 X 1 1/2”

Hex Bolt

1/4-20 Locknut

1/4 Dia.

Clevis Pin

3/32” Dia.
Cotter Pin

Handle

Lever

Handle

Grip

Slide wheels onto end of axle with the

hub facing toward frame. Wheels are
identical to ease assembly. Align the hole in
the wheel hub and the hole in the axle as
shown. Secure drive wheel to axle with 3/16
dia. x 2” cotter pin. Insert 1/8 dia. x 1 1/4”
cotter pin in the hole near the end of axle to
retain free turning wheel.