McCulloch 96182000600 User Manual

12

Release the control bar to remove the slack in the control 

cable (Figure 20).

IMPORTANT: The control cable must contain some slack 

when you disengage the control bar for the auger blades 

to stop properly. 

NOTE:  You may need to adjust the control cable from 

position 1 (default) to position 2 if you notice belt slip 

when the control bar is engaged.

NOTE:  If the control cable is adjusted to position 2, 

ensure that the auger stops properly when the control bar 

is released

Before each session, inspect the auger blades for wear.

When a auger blade edge has worn down have an 

Authorized Service Dealer replace the auger blades and 

the scraper (Figure 22).

Figure 22

 1. Auger blades   

2. Scraper  

 

1

2

1.   With the control bar disengaged, unhook and move 

the control cable to the highest position. (Figure 21).

Figure 20

1. Control bar

1

1. Control bar
2. Adjuster link
3. Cable positions

Figure 21

1

2

3

Position 1: Default position 

(Lower Hole as shown in illustration)

Position 2