Troy-Bilt 1130 User Manual

Page of 32
4
5.
Never run an engine indoors or in a poorly ventilated 
area. Engine exhaust contains carbon monoxide, an 
odorless and deadly gas. 
6.
Do not operate machine while under the influence of 
alcohol or drugs. 
7.
Muffler and engine become hot and can cause a burn. Do 
not touch.
8.
Exercise extreme caution when operating on or crossing 
gravel surfaces. Stay alert for hidden hazards or traffic.
9.
Exercise caution when changing direction and while 
operating on slopes. 
10. Plan your snow-throwing pattern to avoid discharge 
towards windows, walls, cars etc. Thus, avoiding possible 
property damage or personal injury caused by a ricochet. 
11. Never direct discharge at children, bystanders and pets 
or allow anyone in front of the machine. 
12. Do not overload machine capacity by attempting to clear 
snow at too fast of a rate.
13. Never operate this machine without good visibility or light. 
Always be sure of your footing and keep a firm hold on 
the handles. Walk, never run.
14. Disengage power to the auger/impeller when 
transporting or not in use.
15. Never operate machine at high transport speeds on 
slippery surfaces. Look down and behind and use care 
when in reverse. 
16. If the machine should start to vibrate abnormally, stop the 
engine, disconnect the spark plug wire and ground it 
against the engine. Inspect thoroughly for damage. 
Repair any damage before starting and operating.
17. Disengage all controls and stop engine before you leave 
the operating position (behind the handles). Wait until the 
auger/impeller comes to a complete stop before 
unclogging the chute assembly, making any adjustments, 
or inspections. 
18. Never put your hand in the discharge or collector 
openings. Always use the clean-out tool provided to 
unclog the discharge opening. Do not unclog chute 
assembly while engine is running.Shut off engine and 
remain behind handles until all moving parts have 
stopped before unclogging.
19. Use only attachments and accessories approved by the 
manufacturer (e.g. wheel weights, tire chains, cabs etc.).
20. If situations occur which are not covered in this manual, 
use care and good judgment. Contact your dealer or 
telephone 1- 800 520-5520
 
for assistance and the name 
of your nearest servicing dealer.
MAINTENANCE AND STORAGE
1.
Never tamper with safety devices. Check their proper 
operation regularly. Refer to the maintenance and 
adjustment sections of this manual.
2.
Before cleaning, repairing, or inspecting machine 
disengage all controls and stop engine. Wait until the 
auger/impeller come to a complete stop. Disconnect the 
spark plug wire and ground against the engine to prevent 
unintended starting. 
3.
Check bolts and screws for proper tightness at frequent 
intervals to keep the machine in safe working condition. 
Also, visually inspect machine for any damage. 
4.
Do not change the engine governor setting or over-speed 
the engine. The governor controls the maximum safe 
operating speed of the engine.
5.
Snow thrower shave plates and skid shoes are subject to 
wear and damage. For your safety protection, frequently 
check all components and replace with original 
equipment manufacturer’s (OEM) parts only. “Use of 
parts which do not meet the original equipment 
specifications may lead to improper performance and 
compromise safety!”
6.
Check clutch controls periodically to verify they engage 
and disengage properly and adjust, if necessary. Refer to 
the adjustment section in this operator’s manual for 
instructions.
7.
Maintain or replace safety and instruction labels, as 
necessary.
8.
Observe proper disposal laws and regulations for gas, oil, 
etc. to protect the environment.
9.
Prior to storing, run machine a few minutes to clear snow 
from machine and prevent freeze up of auger/impeller.
10. Never store the machine or fuel container inside where 
there is an open flame, spark or pilot light such as a water 
heater, furnace, clothes dryer etc.
11. Always refer to the operator’s manual for proper 
instructions on off-season storage. 
WARNING: Restrict the use of this power 
machine to persons who read, understand 
and follow the warnings and instructions 
in this manual and on the machine.