GE 40350 User Manual

9

carbon Monoxide (co) Detector/ smoke Detector
 

       Carbon Monoxide (CO) detector(s) installed and in working 

order.

 

       Smoke detector(s) installed and in working order.

Placement
 

     Required permits have been obtained.

 

    Generator placed in an area free from Carbon Monoxide 

(CO) buildup. See Placement of Standby Generator to 

 

    Generator placed in an area compliant to NFPA 37. See 

 

    Generator placed in an area free from water damage. See 

 

    Generator placed in an area free from utility and other 

home systems. See Other General Location Guidelines.

 

    Generator placed in a debris free zone. See Other General 

 

     Generator placed on flat ground with provisions for water 

drainage.See Other General Location Guidelines.

fuel
 

    Generator is connected to fuel source with steel flexible 

fuel line, has no fuel leaks and conforms to local codes. See 

 

    Proper fuel pressure has been measured with all gas 

appliances operating. See The Gaseous Fuel System.

 

    Fuel system has been configured for the proper fuel 

supply: Natural gas (NG) or liquefied petroleum ( LP). See 

 

     Fuel type: (circle one)      nG     LP

 

     Fuel pipe size used: (circle one)    3/4”    1”    1-1/4”      1-1/2” 

 

     Fuel pressure at fuel inlet port with generator on and at 

full load and all gas appliances turned on and operating 

electrical
 

    Generator neutral is connected to Automatic Transfer 

Switch. See Generator AC Connection System.

 

Generator is grounded. See Grounding the Generator and 

 

    Generator is connected to the transfer switch with the 

specified wiring. See Utility Circuit Connection and 

 

    Generator is connected to the transfer switch with the 

specified wiring. #18AWG twisted pair wiring from the 

generator control panel to the transfer switch is installed 

in a separate conduit from high voltage wires unless 

the insulation rating on all wiring is rated for 600V See 

 

    Dipswitches in most transfer switches must be set to 

correspond to the wattage of the generator. See Transfer 

 

    Cold weather kit is installed in temperatures below 

XX°F 

(5°C)

. See Cold Weather Kit.

 

    Correct battery type is installed and fully charged. See 

 

    Generator engine oil level is at full mark. See Final 

 

    Circuit breaker is in the ON position. 

 

    Utility was shut off to test the operation of generator and 

transfer switch. Note any fault codes and make corrections 

as required.

 

    AC Voltage Output___________________________.

 

    Frequency Output___________________________.

Proper installation of the home generator requires the completion of the following tasks:

owner information
Name: _____________________________________________
Address: ___________________________________________
___________________________________________________

Phone/e-mail: _______________________________________

unit information
Generator Model: ____________________________________
Generator Serial Number: _____________________________

installing contractor information
Name: _____________________________________________
Address: ___________________________________________
___________________________________________________

Phone/FAX: _________________________________________

Electrician:  _________________________________________
Signature: __________________________________________

Plumber:  ___________________________________________
Signature:  _________________________________________

inspector information
Name: _____________________________________________
Address: ___________________________________________
___________________________________________________

Title: _______________________________________________
Inspection Date: _____________________________________

Installing Contractor Signature:  ______________________________
Date: ____________________________________________________

NOT 

for 

REPRODUCTION