Generac 000 Watt User Manual

Remove all packaging material.

• 

Remove separate accessory box.

• 

Remove the generator from carton.

• 

Check all contents. If any parts are missing or damaged locate an 

authorized dealer at 1-888-436-3722.
Contents Include:

1 – Owner’s Manual 

•  1 - Left Handle Assembly

• 

1 - Quart Oil SAE 30 

•  1 - Right Handle Assembly

• 

2 - Never-Flat Wheels 

•  1 - Frame Foot

• 

1 -  12 volt Adapter Plug  

•  1 - Foot Support

• 

Charger*

1 - Hardware Bag (containing the following):

• 

2 - Rubber Feet 

2 - 5/16” Bolts

2 - 5/16” Flat Washers  4 - 5/16” Locking Flange Nuts
4 - 5/16” Carriage Bolts  2 - 5/16” Locking Cap Nuts
2 - 1/2” Axle Bolts 

2 - 1/2” Locking Flange Nuts

2 - 1/2" Flat Washers

* Electric start units only.

The generator requires some assembly prior to using it. If problems 

arise when assembling the generator, please call the Generator 

Helpline at 1-888-436-3722.

The wheels are designed into the unit to greatly improve the 

portability of the generator.

1.  Refer to Figure 1 and install Wheels as follows:
 

•  Slide the 1/2” Axle Bolt through the 1/2" Washer, the Wheel 

and Wheel bracket on frame.

 

• Install 1/2” Locking Flange Nuts onto 1/2” Flange Bolt.

2.   Refer to Figure 1 and install Frame Foot, Foot Support and 

Rubber Feet as shown.

 

•  Slide Rubber Foot stud through the Foot Support and Frame 

Foot; Install 5/16” Locking Flange Nuts Slide 5/16” Bolt 

through 5/16” Flat Washer and then through holes in Frame 

Rail.

  •  Slide Frame Foot onto 5/16” Bolts; Install 5/16” Locking 

Flange Nuts.

3.  Refer to Figure 2 and install Handles as shown.
 

•  Remove top Curved Head Bolts and Cap Nuts (Cap Nuts will 

be re-used).

 

• Slide Handle Assembly over Frame Tube, aligning 2 holes.

 

• Slide 5/16” Carriage Bolts through; Install 5/16” Cap Nuts.

The unit has been deliberately shipped with the starter cable 

disconnected.
To connect starter:

1.  Locate starter cable (a hang tag is attached as shown in 

Figure 3).

2.  Pull vinyl boot back onto starter cable.
3.  Remove nut and washer from starter post.
4.  Put starter cable onto post and re-install washer and nut.