Symantec 10024709 User Manual
164
Command-line switches
Command-line switches
Command-line switches
-sze
Sets the size for the destination partitions for either a disk restore or disk copy operation.
When numbering partitions in the -sze switch, do not include the hidden Ghost partition.
When numbering partitions in the -sze switch, do not include the hidden Ghost partition.
-szee
Forces Norton Ghost to keep the sizes of all destination partitions the same as in the source
partition (no resizing).
partition (no resizing).
This switch can be used with or without the -clone switch.
-szef
Forces Norton Ghost to keep the sizes of all destination partitions, except for the first one,
the same as in the source partition. The first partition uses the remaining disk space.
the same as in the source partition. The first partition uses the remaining disk space.
This switch can be used with or without the -clone switch.
-szel
Forces Norton Ghost to keep the sizes of all destination partitions, except for the last one,
the same as in the source partition. The last partition uses the remaining disk space.
the same as in the source partition. The last partition uses the remaining disk space.
This switch can be used with or without the -clone switch.
-tapebuffered
Default tape mode. Sets the ASPI driver to report a read/write as successful as soon as the
data has been transferred to memory. Useful when using older or unreliable tape devices or
sequential media.
data has been transferred to memory. Useful when using older or unreliable tape devices or
sequential media.
-tapeeject
Forces Norton Ghost to eject the tape following a tape operation. If the tape drive does not
support remote ejection you must eject and insert the tape manually before further use.
Earlier versions ejected the tape by default. By default, Norton Ghost does not eject the
tape. It rewinds the tape before exiting to DOS.
support remote ejection you must eject and insert the tape manually before further use.
Earlier versions ejected the tape by default. By default, Norton Ghost does not eject the
tape. It rewinds the tape before exiting to DOS.
-tapesafe
Sets the ASPI driver to report a read/write as successful only when the data has been
transferred to the physical medium. Useful when using older or unreliable tape devices or
sequential media.
transferred to the physical medium. Useful when using older or unreliable tape devices or
sequential media.
-tapebsize=x
Specifies the tape block size in units of 512 bytes, where x is 1 to 128.
-tapespeed=x
Allows control of tape speed, where x is 0 to F. 0 is the default. 1 to F increase tape speed.
Only use this when the tape does not work correctly at the speed used by Norton Ghost.
Only use this when the tape does not work correctly at the speed used by Norton Ghost.
-tapeunbuffered
Sets the ASPI driver to report a read/write as successful only when the data has been
transferred to the tape drive. (It is possible that this occurs before the data is physically
written to the medium.)
transferred to the tape drive. (It is possible that this occurs before the data is physically
written to the medium.)
-tcpm[:slave IP address] The TCP/IP master mode switch causes Norton Ghost to go into TCP/IP master mode
automatically, and is the equivalent of selecting TCP/IP Master from the main menu. The
IP address of the slave computer may be specified. See
IP address of the slave computer may be specified. See