Azden 1201URX/VM User Manual

in the illustration. The compartment is deigned to ease battery insertion - With 

the correct polarity. DO NOT FORCE THE BATTERY INTO THE COMPART-

MENT. Azden does not recommend the use of rechargeable batteries.

Before the 1201XT can be used, it and the associated receiver have to be set 

to the same frequency. This can be accomplished on the 1201XT transmit-

ter by first setting the LCD display to one of the two views - ‘Frequency’ or 

‘Channel’. To do this ,after installing fresh batteries, turn the 1201XT to the 

ON position [    ]. Next, using the tip of a ballpoint pen, an unbent paper clip 

or something similar, press the MODE button [    ] repeatedly until one of the 

two screens below appears.

r

n

Using either the UP or DOWN button [    ] the desired receiving frequency 

or channel number can be set. Tapping the button steps the frequency or 

channel number one at a time while pressing and holding the button in moves 

through the frequencies or channel numbers rapidly. There are 188 different 

frequencies or channel numbers to choose from. Once the desired frequency 

or channel number has been determined be certain to set both the transmitter 

and the receiver to match.

o

9

1201URX SERIES RECEIVER VIEW ......................................................... i

INTRODUCTION ........................................................................................ ii

RECEIVER (1201URX/AB and 1201URX/VM) SETUP ..........................1-2

Attaching the Antennas ...............................................................................1

Connecting the Output Cable .....................................................................1

Setting the Receiver’s Frequency ...........................................................1-2

Power .........................................................................................................2

Output .........................................................................................................2

Monitor ........................................................................................................2

LCD Display .............................................................................................2-4

The 1201URX/Si .........................................................................................4

Mode ........................................................................................................4-5

Up/Down .....................................................................................................5

Powering the 1201BT Transmitter ..............................................................6

SETTING THE TRANSMITTING FREQUENCY ON THE 1201BT .........6-7

USING THE 1201BT TRANSMITTER’S CONTROLS AND DISPLAY ........7

Power .........................................................................................................7

Audio ..........................................................................................................7

MIC .............................................................................................................7

Input Level Adjustment ...............................................................................7

Belt Clip ......................................................................................................7

Antenna ......................................................................................................8

Display ........................................................................................................8

THE 1201XT ...............................................................................................8

Powering the 1201XT ..............................................................................8-9

SETTING THE TRANSMITTING FREQUENCY ON THE 1201XT ............9

USING THE 1201XT TRANSMITTER’S CONTROLS AND DISPLAY ......10

Power .......................................................................................................10

Audio ........................................................................................................10

MIC Connector / Locking Ring ..................................................................10

Input Level Adjustment .............................................................................10

Display ...................................................................................................... 11

SPECIFICATIONS .......................................................................Back Page

LICENSING .................................................................................Back Page

CONFORMITY ....................................................................................Insert

iii