Sennheiser 100 G3 User Manual
Using the devices
17
Using the devices
To establish a transmission link, proceed as follows:
1.
Switch the receiver on.
2.
Switch a transmitter on.
The transmission link is established and the receiver’s RF level display “
The transmission link is established and the receiver’s RF level display “
RF
” reacts.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
same channel.
If necessary, read the chapter “If a problem occurs ...” on page 28.
Switching the devices on/off
EM 100 receiver
To switch the receiver
on
:
To switch the receiver to
standby mode
:
If necessary, deactivate the lock mode (see page 21).
It is vital to observe the following notes:
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
information sheet.
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
and, if necessary, apply for an operating license.
쐊
쐊
00
00 G3
MHz
SET
쐂
Briefly press the
STANDBY
button
The receiver switches on and the “
Receiver Parameters
” standard display appears.
Keep the
STANDBY
button
pressed until “
OFF
” appears on the display panel.
When in the operating menu, pressing the
STANDBY
button
will cancel your entry
(ESC function) and return you to the current standard display.