Sennheiser 100 G3 User Manual
Using the devices
20
To switch the radio microphone
on
and to
deactivate the RF signal on switch-on
(offline
operation):
To
activate
the
RF signal
:
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with the receiver. During
synchronization, the following parameters are transferred to the transmitter:
synchronization, the following parameters are transferred to the transmitter:
To transfer the parameters:
Switch the transmitter and the receiver on.
Press the
button
on the receiver.
“
Sync
” appears on the display panel of the receiver.
Place the infra-red interface of the transmitter (see page 7 and 9) in front of the infra-
red interface of the receiver
red interface of the receiver
.
The parameters are transferred to the transmitter. When the transfer is completed, “
”
appears on the display panel. The receiver then switches back to the current standard
display.
display.
To cancel the transfer:
Press the
STANDBY
button on the receiver.
Press the
ON
/
OFF
button
until “
RF Mute On?
” appears on the display panel.
Press the multi-function switch
The transmission frequency is displayed but the radio microphone does not
transmit an RF signal. The transmission icon
transmit an RF signal. The transmission icon
is not displayed.
Use this function to save battery power or to prepare a radio microphone for use
during live operation without causing interference to existing transmission links.
during live operation without causing interference to existing transmission links.
Briefly press the
ON
/
OFF
button
“
RF Mute Off
” appears on the display panel.
Press the multi-function switch
The transmission icon
is displayed again.
ON/OFF
MHz
543.200
ew100 G3
MUTE
P
AF
햵
ON/OFF
Setting
Transferred parameters
“
Frequency Preset
”
Currently set frequency
“
Name
”
Freely selectable name currently set on the receiver
“
Pilot Tone
”
Current pilot tone setting of the receiver (“
Inactive
”/“
Active
”)
쐇
쐃
쐇
쐃