Sony UWP-X1/X2 User Manual

30

Press the SET button for more
than one second.

Keep pressing the SET button
until the display seciton
parameters start to flash.

Press the SET button repeatedly
until the frequency indication
appears and starts flashing.

Press the + or – button to select
the frequency.

When the desired frequency
appears, leave the tuner for about
10 seconds until the selected
channel frequency stops flashing
and the selection is stored in
memory.

• When you are setting the reception

channel, the tuner can be used to
receive signals.

• Do not remove the batteries while

setting the reception channel. If they
are inadvertently removed, re-insert
them immediately and redo the
procedure “Setting the reception
channel” from step 1.

• Make sure that the selected channel

is the same on the transmitter and
tuner being used in the same system.

• If you turn off the tuner and then

immediately turn it on right after
setting the reception channel, the unit
may not operate normally. Wait a
few seconds before turning it on
again.

When multiple diversity tuner
modules (URX-M1) are installed into
the MB-806 to perform simultaneous
multiple-channel operation, select the
channel group on the tuner module
installed into the slot 1 of the MB-
806, then all the tuner mudules
installed into the MB-806 can be set to
different channels within the selected
channel group.

Turn off all the microphones and
transmitters.

Select the channel group on the
tuner module installed into the
slot 1 of the MB-806.

After confirming that the channel
group indication has stopped
flashing (about 10 seconds after
you have selected the channel
group), keep pressing the + button
on the tuner module installed into
the slot 1 of the MB-806.