Sony X8 User Manual
52
Tuner Settings
4
When the desired frequency appears,
leave the tuner for about 10 seconds or
press down the SET button for more
than one second.
leave the tuner for about 10 seconds or
press down the SET button for more
than one second.
The selected channel number stops
flashing and the selection is stored in
memory.
flashing and the selection is stored in
memory.
• Even when you are setting the reception
channel, the tuner can be used to receive
signals.
signals.
• Do not remove the batteries while setting
the reception channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
“Setting the reception channel” from
step 1.
inadvertently removed, re-insert them
immediately and redo the procedure
“Setting the reception channel” from
step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
used in the same system.
• If you turn off the tuner and then
immediately turn it on right after setting
the reception channel, the unit may not
operate normally. Wait a few seconds
before turning it on again.
the reception channel, the unit may not
operate normally. Wait a few seconds
before turning it on again.
Searching the available
channels within the group
(Clear Channel Scan)
channels within the group
(Clear Channel Scan)
The procedure below can be
performed with the portable
diversity tuner (URX-P2) only.
performed with the portable
diversity tuner (URX-P2) only.
Available channels within the specified
channel group can be searched.
Before performing this procedure, select
the channel group.
channel group can be searched.
Before performing this procedure, select
the channel group.
For details on channel group selection, see “Setting
the reception channel” on page 50.
the reception channel” on page 50.
1
While pressing down the SET button,
press the + button.
press the + button.
Keep both buttons pressed down.
2
Release the SET button and the +
button after “SCAN +” appears and
starts flashing.
button after “SCAN +” appears and
starts flashing.
3
Press the + button.
The tuner starts to scan through the
selected channel group. When
available channels are found, the first
channel number among the available
channels flashes in the display.
selected channel group. When
available channels are found, the first
channel number among the available
channels flashes in the display.
To display the next available
channel number
Press the + button.
channel number
Press the + button.
To cancel searching
Press the – button. The display shows
the flashing “SCAN +” again.
Press the – button. The display shows
the flashing “SCAN +” again.
To re-select the channel group
Press the SET button again to display
the flashing channel group indication,
then select the channel group. And
then, start from step 1.
Press the SET button again to display
the flashing channel group indication,
then select the channel group. And
then, start from step 1.
4
While the desired channel number is
flashing, leave the tuner for about 10
seconds or press down the SET button
for more than one second.
flashing, leave the tuner for about 10
seconds or press down the SET button
for more than one second.
Search finishes. The selected channel
number stops flashing and the
selection is stored in memory.
number stops flashing and the
selection is stored in memory.
To start searching while
performing settings
performing settings
While the display section parameters are
flashing, press the SET button repeatedly
flashing, press the SET button repeatedly
Notes