Nady Systems ENCORE2HTSYSH User Manual

1. Rackmounting the Receiver
There are two options available for rackmounting the Encore II receiver:

singly or side‑by‑side with another Encore Series receiver.

a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of

the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9).

b. Side-by-side double mounting: After removing the SIDE MOUNT CLIPS (1) from

both Encore receivers, join the two receivers with the EJC-2 JOINING CLIP (10)

and attach the ERM-22 RACK EARS (12) as shown.

(Note: Do not mount the receiver in a rack directly above an amplifier or

other source of high heat — this could degrade the performance of the

Encore I. Always ensure adequate airflow and heat dissipation in any rack

configuration.)

2. Powering the Receiver
Plug the 12V AC/DC ADAPTER (15) provided into the DC INPUT JACK (11) on

the back of the receiver. Then plug the power supply into an AC outlet.

(Note: Any 12V DC source with 400mA capability can also be used.)

Press the POWER SWITCH (8) once to turn on the receiver. The POWER ON LED (7)

will now light and the receiver is operational.

3. Antennas
The Encore II receiver is supplied with TELESCOPIC ANTENNAS (16). These should be

extended fully to obtain maximum range. Optimal antenna position is 45 degrees

from the receiver (at 90 degrees from each other). For maximum range, it is always

best to maintain a line of sight (no obstructions) between the receiver antennas and

the transmitter at all times whenever possible.

4. Mute (Squelch) Adjustment
In normal operation, the MUTE CONTROL (2) should be set fully counterclockwise to

the factory preset minimum RF level. However, in areas of high RF activity, the mute

(or squelch, as it is sometimes called) may need to be adjusted to compensate for the

adverse conditions in a particular location. If, with the transmitter off, the receiver’s

A and/or B DIVERSITY LED INDICATORS (3) and/or one or more LEDs of the 5 LED RF

LEVEL DISPLAY (4)

flicker or stay on, the squelch control should be turned clockwise

until the LEDs extinguish. When the squelch is properly adjusted, the A and/or B

LEDs or the RF LEVEL LED displays will only light when the system transmitter is turned

on. Turning the squelch control too far clockwise will reduce the range, but yield a

quieter mute (squelch) function. During operation, especially at ranges greater than

75 feet, one or the other of the A or B LEDs may extinguish briefly. This is normal—

the unit’s DigiTRU Diversity

™

reception ensures that the received audio will not be

interrupted. When both the A/B DIVERSITY LEDs and the 5 LED RF LEVEL display

extinguish, the transmitter is out of range for that given location, and the user should

move closer to the receiver to re‑establish the radio link.

ENCORE II RECEIVER