Yamaha 01X User Manual

Setting Up

01X Owner’s Manual

Before Using

Basics Section

Appendix

Getting Started

Reference

Setting Up

Make sure that the 01X’s [STANDBY/ON] switch is set to

the STANDBY (off) position.

q Connect one end of the AC cable to the PA-300.

w Connect the PA-300’s DC plug to the 01X’s DC IN ter-

minal on the rear panel.

e Connect the other end (normal AC plug) to the nearest

electrical outlet.

• When unplugging the AC Adaptor, disconnect it in reverse order from

that above.

• Do not attempt to use an AC adaptor other than the Yamaha PA-

300 or an equivalent recommended by Yamaha. The use of an

incompatible adaptor may cause irreparable damage to the 01X,

and may even pose a serious shock hazard! ALWAYS UNPLUG

THE AC ADAPTOR FROM THE AC POWER OUTLET WHEN THE

01X IS NOT IN USE.

• Even when the switch is in the “STANDBY” position, electricity

is still flowing to the instrument at a minimum level. When not

using the 01X for an extended period of time, be sure to unplug

the AC power adaptor from the wall AC outlet.

Once you’ve made all the necessary connections (page 23)

between your 01X and any other devices, make sure that

all volume settings are turned down all the way to zero,

then turn on the every device in your setup in the order of

MIDI masters (senders), MIDI slaves (receivers), then

audio equipment (mixers, amplifiers, speakers, etc.). This

ensures smooth signal flow from the first device to the last

(first MIDI, then audio).

• Before beginning installation of mLAN Driver for Windows, switch off

the power to the 01X (see the separate Installation Guide).

• When powering down the setup, first turn down the volume for each

audio device, then switch off each device in the reverse order (audio
devices first, then MIDI).

• Be sure to restart your DAW after restarting the 01X (turning the

power off and on again) or switching the DAW in the Remote Select
menu (page 87). (This applies when using SQ01, Cubase/Nuendo or
Digital Performer.)

• Before you switch your 01X on or off, turn down the volume of

any connected audio equipment.

• Noise may be generated during the following operations. Before

performing these operations, lower the output level of each
device.

• Turning the power to the computer and mLAN devices on or

off

• Connecting or disconnecting an IEEE1394 (mLAN) cable
• Starting or quitting the OS

q Press the [STANDBY/ON] switch.

A splash screen is displayed. The Inter-
nal mode (Home) screen appears next.

w Raise the sound system volume to a rea-

sonable level.

e Turn the 01X’s MONITOR/PHONES

knob clockwise to set an appropriate vol-
ume level.

Power Supply

Power-on Procedure

Rear Panel

PA-300

DC IN

AC cable

To electrical

outlet

Turning on the 01X

POWER

ON!!