Korg Ax3000b User Manual

54

6. Press the AX3000B’s WRITE button to begin transmitting. When transmitting is 

completed, the display will indicate “COMPLETE,” and you will return to the 
screen of step 4. (While “DUMP ALL” is being transmitted, the display will indi-
cate “SEND.”)

NOTE: While data is being transmitted, do not touch the buttons or knobs of the 
AX3000B or its foot controller, and never turn off the power.

1. Connect the transmitting device’s MIDI OUT to the AX3000B’s MIDI IN.

2. Set the transmitting MIDI device and the AX3000B to the same MIDI channel. 

If the AX3000B will be receiving data that was previously transmitted to the 
external MIDI device, select the same MIDI channel as was used when trans-
mitting.

3. Transmit the data dump from the external device.

While the AX3000B is receiving all data, its display will indicate “RECEIVE.” 
When reception has been successfully completed, it will indicate “COM-
PLETE.” If an error occurs, the display will indicate “ERROR”; in this case, try 
transmitting the data again.

NOTE: For details, refer to the owner’s manual of the device that will be transmit-
ting the data dump.

NOTE: While data is being transmitted, don’t touch the AX3000B’s buttons, pedals, 
or knobs, and never turn off the power.

4. If you received data for a single program, select the save-destination bank and 

program, and save the data. (p.19)

NOTE: The program data will not be written into the AX3000B’s program memory 
unless you store it.

If the AX3000B receives all data, all of its data will be overwritten automati-

cally. However, the data currently being edited (i.e., the edit buffer) will not be 
affected.