Panasonic SX-KN7000 User Manual

Page of 211
Symptoms which appear to be signs of trouble
The following changes in performance may occur in the Technics Keyboard but do not indicate trouble.
Phenomenon
Remedy
Soun
ds and
 e
ff
e
c
ts
The buttons, keys, etc. malfunction.
• Turn off the POWER button once, then turn it on again.
If this procedure is not successful, turn off the POWER
button once. Then, while pressing the three lower left
buttons in the RHYTHM GROUP section (60’s & 70’s,
MODERN DANCE and SOUL & R&B) at the same
time, turn the POWER button on again. (Note that, in
this case, all programmable settings, functions and
memories return to their factory-preset status.)
No sound is produced when the keys are pressed.
• The MAIN VOLUME is at the minimum setting. Adjust
the volume with the MAIN VOLUME control.
• The volumes for the selected parts are set to the
minimum levels. Use the balance buttons to set the
volumes of the relevant parts to appropriate levels.
(Refer to page 29.)
• The part is muted. (Refer to page 29.)
• The LOCAL CONTROL for a part performed on the
keyboard is set to OFF. Set the LOCAL CONTROL to
ON. (Refer to page 190.)
Only percussive instrument sounds are produced
when the keyboard is played.
• In the SOUND GROUP section, the DRUM KITS
button is on.
The volume is very low when the keyboard is
played.
• The volume setting in the SEQUENCER contents is
very low. Follow the INITIAL procedure to reset the
settings. (Refer to page 197.)
The sound you hear is different from the sound you
selected.
• This sometimes occurs when you play back
SEQUENCER or COMPOSER data which was created
on a different model, or when MIDI data is received
from a connected instrument. Select the desired
sounds again.
Rh
y
thm
The rhythm does not start.
• The DRUMS volume is set to the minimum level. Use
the balance buttons to set the DRUMS volume to an
appropriate level.
• A  SEQUENCER PLAY button is on. When you are
not playing back the SEQUENCER performance, turn
off the SEQUENCER PLAY button.
• CLOCK is set to MIDI. Set CLOCK to INTERNAL.
(Refer to page 191.)
AUT
O PL
AY
CHORD
No sound is produced for the automatic accom-
paniment, or only the sounds of some parts are
produced.
• An ACCOMP part does not sound if its corresponding
volume is set to the minimum level. Use the respective
balance buttons to set the ACCOMP 1– 5 volumes to
appropriate levels.
SEQUENCER
Storage is not possible.
• The remaining memory capacity of the SEQUENCER
is 0. Follow the SONG CLEAR or TRACK CLEAR
procedure to erase the memory. (Refer to page 97.)
The playback measure indication is different from
when the performance was recorded.
• The number of measures corresponds to the time
signature of the rhythm selected at the start of
recording. To change the rhythm in the middle of the
song, record the rhythm change in the RHYTHM part.
(Refer to page 94.)
201
QQTG0671