Roland VS-1824 User Manual
266
Chapter 22 Specific Applications
Controller numbers correspond to the input channel
parameters as follows.
parameters as follows.
Controller Number
Mixer Parameter
68
MIX Send Level
70
MIX Send Pan
71
EQ L Freq.
72
EQ L Gain
73
EQ M Freq.
74
EQ M Gain
75
EQ M Q
76
EQ H Freq.
77
EQ H Gain
78
FX1 SND Level
79
FX1 SND Pan/Balance
80
FX2 SND Level
81
FX2 SND Pan/Balance
82
AUX1 (* FX3) SND Level
83
AUX1 (* FX3) SND Pan/Balance
84
AUX2 (* FX4) SND Level
85
AUX2 (* FX4) SND Pan/Balance
86
AUX3 (* AUX) SND Level
87
AUX3 (* AUX) SND Pan/Balance
88
MIX Offset Level
89
MIX Offset Balance
* When you are installing two effect expansion boards.
Controller numbers correspond to the Master Block
parameters as follows.
parameters as follows.
Controller Number
Mixer Parameter
68
Master Level
70
Master Balance
78
FX1 SND Level
79
FX1 SND Balance
80
FX2 SND Level
81
FX2 SND Balance
82
AUX1 (* FX3) SND Level
83
AUX1 (* FX3) SND Balance
84
AUX2 (* FX4) SND Level
85
AUX2 (* FX4) SND Balance
86
AUX3 (* AUX) Level
87
AUX3 (* AUX) Balance
102
Monitor Level
103
Monitor Balance
* When you are installing two effect expansion boards.
Preparations for Compu Mix
1. Make connections as shown below.
fig.13-07
2. Hold [SHIFT] and press [F5 (SYSTEM)]. The System
Menu appears in the display.
If the System Menu does not appear, press [F6 (EXIT)].
3. Press [F4 (MIDI)]. If “MIDI” does not appear above [F4],
press [PAGE] until “MIDI” appears, then press [F4
(MIDI)].
(MIDI)].
4. Use [
], [
], [
], and [
] to move the
cursor and use the TIME/VALUE dial to make settings
for each parameter as described below.
for each parameter as described below.
MIDI Thru (MIDI Thru Switch)
For this application, set this to “OUT.”
Cntrl Local (Control Local Switch)
For this application, set this to “On.”
Control Type (Mixer Control Types)
For this application, set this to “C.C.”
5. Follow the procedure described in “Synchronizing with
MIDI Sequencers” (“Synchronizing with MIDI
Sequencers,” p. 197) to make the necessary settings in
both the VS-1824 and the MIDI sequencer to synchronize
the two machines. Make sure to set the MIDI sequencer
so MIDI messages received at the MIDI In connector are
not output from the MIDI Out connector.
Sequencers,” p. 197) to make the necessary settings in
both the VS-1824 and the MIDI sequencer to synchronize
the two machines. Make sure to set the MIDI sequencer
so MIDI messages received at the MIDI In connector are
not output from the MIDI Out connector.
MIDI OUT
MIDI Sequencer
MIDI OUT