Edirol FA-101 User Manual

Front and rear panel

fig.rear

17. Power switch

Used to switch the power on (DC IN) or off (OFF), and for switching to bus power (BUS).

fig.power-sw

BUS

Bus power can be used if the FA-101 is connected to your computer via a FireWire (IEEE 1394)
cable. In this case, power is supplied from your computer via the FireWire (IEEE 1394) cable.
If you want to use bus power, set the power switch to the BUS position.

fig.6-pin

•

6-pin type

You can use bus power if your computer has a 6-pin IEEE 1394 connector (FireWire
connector, iLink connector, DV connector).

With some computers, the FA-101 may not operate on bus power. If so, connect the included AC
adaptor to an AC outlet and use it to supply power to the FA-101. In this case, the power will be on
when you set the power switch to the DC IN position.

fig.4-pin

•

4-pin type

If your computer has a 4-pin FireWire (IEEE 1394) connector, you cannot use bus power.
Set the power switch to the DC IN position.

18. AC adaptor jack

Connect the included AC adaptor to this jack.

* Never use any AC adaptor other than the supplied unit; doing so may cause malfunction.

19. Phantom power switch

This is an on/off switch for the phantom power supplied to the XLR connectors of the

combo input jacks

(1)

on the front panel.

* You must leave the phantom power turned off (right position) unless condenser mics requiring phantom power are

connected to the XLR jacks. Supplying phantom power to a dynamic mic or an audio playback device may cause
malfunction. For details on the requirements of your mic, refer to its owner’s manual.
(The FA-101’s phantom power supply: DC 48 V, 20 mA maximum)

Rear panel

18 19 20

22 23

FA-101_e.book 12 ページ２００５年１１月２４日　木曜日　午後１時２５分