Edirol FA-101 User Manual
43
Troubleshooting
Is the FA-101 connected to a FireWire (IEEE 1394) hub?
Try connecting the FA-101 directly to the FireWire (IEEE 1394) connector of your computer itself.
Noise may be entering via the line inputs or mic inputs.
If a MIDI sound module with a FireWire (IEEE 1394) connector is connected via FireWire (IEEE 1394) to the
same computer as the FA-101, and the output of the MIDI sound module is connected to the input jacks of the
FA-101, noise from the computer may be heard via the MIDI sound module from the FA-101. In this case, you
can either connect the MIDI sound module and FA-101 in parallel via a self-powered hub, or connect the MIDI
sound module in series or via a MIDI interface.
same computer as the FA-101, and the output of the MIDI sound module is connected to the input jacks of the
FA-101, noise from the computer may be heard via the MIDI sound module from the FA-101. In this case, you
can either connect the MIDI sound module and FA-101 in parallel via a self-powered hub, or connect the MIDI
sound module in series or via a MIDI interface.
While you were using the FA-101, could your computer have performed a task with a heavy
processing load, such as accessing a CD-ROM drive or network?
processing load, such as accessing a CD-ROM drive or network?
If a heavy processing load occurs while the FA-101 is being used, it may not work correctly. In this case, stop
playback/recording, and then start playback/recording once again. If you are still unable to play/record
correctly, close all software that had been using the FA-101, and re-connect the FA-101.
playback/recording, and then start playback/recording once again. If you are still unable to play/record
correctly, close all software that had been using the FA-101, and re-connect the FA-101.
Is the sample rate setting in your software the same as the sample rate of the digital device
connected to the digital input connector?
connected to the digital input connector?
Set your software and the FA-101 to the same sample rate.
If you switch the FA-101's sample rate, you must turn the power of the FA-101 off, then on again to get the
setting to take effect.
If you switch the FA-101's sample rate, you must turn the power of the FA-101 off, then on again to get the
setting to take effect.
Playback/recording stops midway, and subsequent playback/recording is not possible
Digitally recorded sound has distortion, the wrong pitch, or contains noise
FA-101_e.book 43 ページ ２００５年１１月２４日 木曜日 午後１時２５分