Edirol UA-1000 User Manual
11
Panel Descriptions
Front panel
fig.front
1.
Combo input jacks 1–4
These are analog audio input jacks with high-quality
preamps. Either XLR type or phone type jacks can be
connected here, as appropriate for the equipment you are
using. Balanced or unbalanced connections are supported.
preamps. Either XLR type or phone type jacks can be
connected here, as appropriate for the equipment you are
using. Balanced or unbalanced connections are supported.
The XLR type jacks provide 48 V phantom power, allowing
you to connect phantom-powered condenser mics. In this
case, turn on the phantom power switch.
you to connect phantom-powered condenser mics. In this
case, turn on the phantom power switch.
fig.XLR-TRS
* This instrument is equipped with balanced (XLR/TRS) type input
jacks. Wiring diagrams for these jacks are shown on the right.
Make connections after first checking the wiring diagrams of other
equipment you intend to connect.
Make connections after first checking the wiring diagrams of other
equipment you intend to connect.
2.
Input sensitivity knobs
These adjust the input level of the signals that are input to front panel
combo input jacks 1–4
and rear panel
input
jacks 5–8
.
fig.sens
3.
Phantom power switches 1, 2 (PHANTOM 48 V)
These are on/off switches for the phantom power that is supplied to the XLR type connectors of
combo input jacks
1–2
and
3–4
. Phantom power is on when the switch is pressed inward ( ), and off when the switch is in the outward
position ( ).
fig.jack-type
* You must turn phantom power off (button in the outward position) unless a condenser
microphone requiring a phantom power supply is connected to the XLR type jacks.
Malfunctions will occur if you supply phantom power to a dynamic microphone or to an
audio playback device. For details on the specifications of your microphone, refer to the
owner’s manual for your microphone.
Malfunctions will occur if you supply phantom power to a dynamic microphone or to an
audio playback device. For details on the specifications of your microphone, refer to the
owner’s manual for your microphone.
(The UA-1000 supplies phantom power at DC 48 V, maximum 10 mA x 2 systems)
4.
Gain select switches (PAD)
These switch the input level. Turn these on (button in the inward position) if you connect devices that have a high
output gain.
output gain.
fig.panel-input
1
2
5
3
4
6
1:GND
2:HOT
3:COLD
2:HOT
3:COLD
GND(SLEEVE)
HOT(TIP)
COLD(RING)
2
XLR plug
TRS phone
plug
(balanced)
Phone plug
(unbalanced)
UA-1000_e.book 11 ページ ２００３年８月６日 水曜日 午前１１時５２分