Edirol UA-1000 User Manual

 

291b

 

301

 

• Do not use this unit on the same power circuit with any 

device that will generate line noise (such as an electric 
motor or variable lighting system).

 

307

 

• Before connecting this unit to other devices, turn off the 

power to all units. This will help prevent malfunctions 
and/or damage to speakers or other devices.

 

308

 

• Although the LCD and LEDs are switched off when the 

POWER switch is switched off, this does not mean that the 
unit has been completely disconnected from the source of 
power. If you need to turn off the power completely, first 
turn off the POWER switch, then unplug the power cord 
from the power outlet. For this reason, the outlet into 
which you choose to connect the power cord’s plug 
should be one that is within easy reach.

 

351

 

• Using the unit near power amplifiers (or other equipment 

containing large power transformers) may induce hum. 
To alleviate the problem, change the orientation of this 
unit; or move it farther away from the source of inter-
ference.

 

352a

 

• This device may interfere with radio and television 

reception. Do not use this device in the vicinity of such 
receivers.

 

352b

 

• Noise may be produced if wireless communications 

devices, such as cell phones, are operated in the vicinity of 
this unit. Such noise could occur when receiving or initi-
ating a call, or while conversing. Should you experience 
such problems, you should relocate such wireless devices 
so they are at a greater distance from this unit, or switch 
them off.

 

355b

 

• When moved from one location to another where the 

temperature and/or humidity is very different, water 
droplets (condensation) may form inside the unit. Damage 
or malfunction may result if you attempt to use the unit in 
this condition. Therefore, before using the unit, you must 
allow it to stand for several hours, until the condensation 
has completely evaporated.

 

401a

 

• For everyday cleaning wipe the unit with a soft, dry cloth 

or one that has been slightly dampened with water. To 
remove stubborn dirt, use a cloth impregnated with a 
mild, non-abrasive detergent. Afterwards, be sure to wipe 
the unit thoroughly with a soft, dry cloth.

 

402

 

• Never use benzine, thinners, alcohol or solvents of any 

kind, to avoid the possibility of discoloration and/or 
deformation.

 

452

 

• Please be aware that all data contained in the unit's 

memory may be lost when the unit is sent for repairs. 
Important data should always be written down on paper. 
During repairs, due care is taken to avoid the loss of data. 
However, in certain cases (such as when circuitry related 
to memory itself is out of order), we regret that it may not 
be possible to restore the data, and Roland assumes no 
liability concerning such loss of data.

 

551

 

• Please be aware that the contents of memory can be 

irretrievably lost as a result of a malfunction, or the 
improper operation of the unit. To protect yourself against 
the risk of losing important data, we recommend that you 
periodically write down important data you have stored 
in the unit's memory on paper.

 

552

 

• Unfortunately, it may be impossible to restore the contents 

of data that was stored in the unit’s memory once it has 
been lost. Roland Corporation assumes no liability 
concerning such loss of data.

 

553

 

• Use a reasonable amount of care when using the unit’s 

buttons, sliders, or other controls; and when using its jacks 
and connectors. Rough handling can lead to malfunctions.

 

556

 

• When connecting / disconnecting all cables, grasp the 

connector itself—never pull on the cable. This way you 
will avoid causing shorts, or damage to the cable’s 
internal elements.

 

557

 

• A small amount of heat will radiate from the unit during 

normal operation.

 

558a

 

• To avoid disturbing your neighbors, try to keep the unit’s 

volume at reasonable levels. You may prefer to use 
headphones, so you do not need to be concerned about 
those around you (especially when it is late at night).

 

559a

 

•  When you need to transport the unit, package it in the box 

(including padding) that it came in, if possible. Otherwise, 
you will need to use equivalent packaging materials.

 

562

 

• Use a cable from Roland to make the connection. If using 

some other make of connection cable, please note the 
following precautions.

• Some connection cables contain resistors. Do not use 

cables that incorporate resistors for connecting to this 
unit. The use of such cables can cause the sound level 
to be extremely low, or impossible to hear. For infor-
mation on cable specifications, contact the manufac-
turer of the cable.

UA-1000_e.book 5 ページ ２００３年８月６日　水曜日　午前１１時５２分