Behringer WD300 Owner's Manual

Ultimate Warp Distortion Effects Pedal

Thank you for showing your confidence in us by purchasing the BEHRINGER WARP DISTORTION WD300. 

This high-quality effects pedal enables you to produce super thick, tube-like distortion plus 

endless sustain. Thanks to its high-performance features you can achieve the typical hard rock 

or heavy metal distortion sounds.

(1) 

The SUB switch activates a low-frequency boost at around 90 Hz to simulate the resonance 

frequency of a 4 x 12" cabinet.

(2) 

The LEVEL control adjusts the output level.

(3) 

The WARP control adjusts the mid-frequency range. It boosts the mids from 250 Hz to 1 kHz at 

minimum position. In maximum position it cuts mids at 500 Hz with a presence boost at 3 kHz.

(4) 

The GAIN control adjusts the input sensitivity and the amount of resulting distortion.

(5) 

The ON/BATT LED illuminates when the effect is activated. It also serves as a battery 

level indicator.

(6) 

Use the footswitch to activate/deactivate the effect.

(7) 

Use this 1/4" TS IN connector to plug in the instrument cable. 

(8) 

The 1/4" TS OUT connector sends the signal to your amp.

Use the DC IN connection to plug in a 9 V power supply (not included). 
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery 

(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to 

scratch the unit.

(5)

(1)

(7)

(4)

(6)

(3)

(2)

(8)