Roland HPi-6 User Manual
69
Recording Your Performance
1.
Use the [
(Bwd)] or [
(Fwd)] button to move to the measure that
you want to re-record.
2.
Press the [
(Rec)] button.
A screen like the one shown below appears.
fig.Rec-OverRec1-e
3.
Press the
cursor left or right button to select <Add On>, then press
the [
] button
This sets the HPi-6 so you can record while listening to the song already recorded.
fig.d-Rec-OverRec2-e_50
4.
Press the track button for the track that you want to re-record.
The indicators of the button you pressed and of the [
(Play/Stop)] button will
blink, and the HPi-6 enters recording-standby mode.
5.
Press the [
(Play/Stop)] button to start recording.
The count is played, and then recording begins.
When recording begins, the [
(Play/Stop)] button and [
(Rec)] button
indicators will light.
Go ahead and perform on the keyboard.
Re-recording
When you want to re-record, specify the track button whose performance you want to re-record, then record again.
When you select a previously recorded track button and re-record, the performance from the location at which
you begin recording up to the location at which you stop recording will be replaced by the newly re-recorded
performance.
you begin recording up to the location at which you stop recording will be replaced by the newly re-recorded
performance.
fig.panel-Rec-ReRec-e
When you want to record over
again after deleting all of the
previous recording, refer to
“Erasing a Recorded Song” (p.
70).
again after deleting all of the
previous recording, refer to
“Erasing a Recorded Song” (p.
70).
When deleting the
performance for a specific
track button, refer to “Erasing
the Performance on Specific
Tracks” (p. 70).
performance for a specific
track button, refer to “Erasing
the Performance on Specific
Tracks” (p. 70).
The selected setting turns
orange.
orange.
NOTE
The song tempo is stored
within the song you selected.
within the song you selected.
HPi-6-e.book 69 ページ ２００５年１１月１５日 火曜日 午後３時４９分