Pelco KBD300A User Manual
[ 32 ]
Pelco Manual C527M-L (3/04)
Programming Limit Stops
Spectra and Esprit can be programmed for scan and manual limit stops.
Program left limit before programming right limit. Locate camera at desired limit. Enter the set code from
Table G. Hold the PRESET key for two seconds. In CM6700 and CM6800 modes, a label appears on the
monitor. Use F1 and F2 to edit the label, then select SET and press ACK or tap the joystick to the right and
release.
Table G. Hold the PRESET key for two seconds. In CM6700 and CM6800 modes, a label appears on the
monitor. Use F1 and F2 to edit the label, then select SET and press ACK or tap the joystick to the right and
release.
To cancel all limit stops, enter 95. Hold the preset key for two seconds. Move joystick up or down to move
the pointer to Other. Press IRIS OPEN. Move the pointer to Limit Stops. Press IRIS OPEN. Move joystick
right/left to change limit stops to off. Press IRIS OPEN. Move the pointer to EXIT. Press IRIS OPEN. Move
pointer to exit. Press IRIS OPEN.
the pointer to Other. Press IRIS OPEN. Move the pointer to Limit Stops. Press IRIS OPEN. Move joystick
right/left to change limit stops to off. Press IRIS OPEN. Move the pointer to EXIT. Press IRIS OPEN. Move
pointer to exit. Press IRIS OPEN.
Table G. Limit Set Codes
Direction
Scan Limit
Manual Limit
Left Limit
92
90
Right Limit
93
91