Roland 5 User Manual
Power up diagnostics and actions
Power up diagnostics and actions
Power up diagnostics and actions
Power up diagnostics and actions
Europa User Guide
Europa User Guide
Europa User Guide
Europa User Guide
Page 18
E
E
E
E----6
6
6
6
Roland factory patches reloaded. This occurs when Europa has been ordered to reload
Roland factory patches/presets into its NVRAM and flash via holding BENDER
Roland factory patches/presets into its NVRAM and flash via holding BENDER
BENDER
BENDER
BENDER
and
powering the board on.
E
E
E
E----7
7
7
7
Patches and presets copied from internal flash to NVRAM. This converts presets from
Europa format back to Roland format so the Roland code can read the patches and
presets. Note that many Europa specific settings are lost if the data is copied to NVRAM,
and then back to flash. This is accomplished by holding GLISSANDO
Europa format back to Roland format so the Roland code can read the patches and
presets. Note that many Europa specific settings are lost if the data is copied to NVRAM,
and then back to flash. This is accomplished by holding GLISSANDO
GLISSANDO
GLISSANDO
GLISSANDO
and powering
up.
Group F boot codes
Group F boot codes
Group F boot codes
Group F boot codes
The F group of boot codes indicates diagnostic failures that Europa has detected, but cannot correct, due
to the memory protect switch being on. One or more of these codes will be shown, but the board will not
boot further, as they are hard failures that need to be corrected before board operation can occur:
The F group of boot codes indicates diagnostic failures that Europa has detected, but cannot correct, due
to the memory protect switch being on. One or more of these codes will be shown, but the board will not
boot further, as they are hard failures that need to be corrected before board operation can occur:
F
F
F
F----4 to F
4 to F
4 to F
4 to F----5
5
5
5
Identical to E
E
E
E----4
4
4
4
and E
E
E
E----5
5
5
5
as listed in the prior E
E
E
E
group section, but the
conditions are not correctable due to the memory protect switch being on. To
correct, power off the Jupiter 6, disable the memory protect, and power the
Jupiter 6 on.
correct, power off the Jupiter 6, disable the memory protect, and power the
Jupiter 6 on.
F
F
F
F----6
6
6
6
Indicates that one or both voice boards are not responding. This fault can also
show up if the voice boards’ connections to the controller board were installed
backwards or are not making a solid connection to the controller board.
show up if the voice boards’ connections to the controller board were installed
backwards or are not making a solid connection to the controller board.
F
F
F
F----7
7
7
7
Identical
to
E
E
E
E----7
7
7
7
above, but indicates that the copy to NVRAM is not possible
because the memory protect switch is on.