Roland FC-200 User Manual
27
Octave Shift Upper Limit Setting: C0 to C6 to C8
[ ] (High)
In the Note mode, a foot pedal connected to FOOT SW/EXP jack 5 can be used to raise the note
range an octave at a time. This parameter sets the upper limit for raising the note range with the
Octave Shift-Up function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
range an octave at a time. This parameter sets the upper limit for raising the note range with the
Octave Shift-Up function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
* The upper limit cannot be set to a value less than the setting made for the Octave Shift Lower
Limit.
* “C6” refers to a C note (“do”) two octaves higher than middle C (“C4”) on a piano keyboard.
C1
C2
C3
C4
C5
C6
C7
C8
Octave Shift Lower Limit Setting: C0 to C2 to C8
[
] (Low)
In the Note mode, a foot pedal connected to FOOT SW/EXP jack 6 can be used to lower the note
range an octave at a time. This parameter sets the lower limit for lowering the note range with the
Octave Shift-Down function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
range an octave at a time. This parameter sets the lower limit for lowering the note range with the
Octave Shift-Down function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
* The lower limit cannot be set to a value higher than the setting made for the Octave Shift Upper
Limit.
* “C2” refers to a C note (“do”) two octaves lower than middle C (“C4”) on a piano keyboard.
C1
C2
C3
C4
C5
C6
C7
C8
Note On Velocity Setting: 1 to 96 to 127
[
] (Note On)
This setting determines the volume of the sound produced when a pedal is depressed in the Note
mode. When the velocity is set to a value of 100 or higher, the point indicator at the top left of the
display lights up, and only the last two digits of the value appear on the display.
mode. When the velocity is set to a value of 100 or higher, the point indicator at the top left of the
display lights up, and only the last two digits of the value appear on the display.
* If you need information on how to make settings for parameters, see “How to Make Changes” (p. 19).