PYLE Audio PPDLUW2 Leaflet

PPDLUW2

 

AUTO-WAH 

1. The RATE control determines the speed of the Wah effect 
modulation. 

 
2. The DEPTH control adjusts the sweep range of the effect. 

At minimum position no modulation effect is produced and 
the Wah effect is controlled by your playing intensity only. 

 
3. The MANUAL control adjusts the basic frequency where 
the effect starts working. High MANUAL settings will decrease 

the sweep range, because the low end of the frequency 
sweep is moved upwards. 

 
4. The SENS control adjusts the sensitivity of the effect. 

Nearing maximum position you achieve Wah effect even with 
soft playing, nearing minimum position the Wah effect will not 
be dependent on your playing dynamics

. 

 
5. The ON/BATT LED illuminates when the effect is 
activated. It also serves as a battery level indicator. 

 
6. Use the Footswitch to activate/deactivate the effect. 

 
7. Use this 1/4 TS IN connector to plug in the instrument cable. 

 
8. The 1/4 TS OUT connector sends the signal to your amp.  

 

Use the DC IN connection to plug in a 9v power supply (not included). The Battery Compartment is 

located underneath the pedal cover. To install or replace the 9v battery, press the hinges with a pen 

and remove the pedal cover. 

 

This effects pedal has no on/off switch. As soon as you insert the jack into the Input connector, the 
pedal will turn on. When not in use, remove the jack from the input connector to save the batteries. 

 

Input Connector: 1/4 TS Impedance 500k 
Output Connector: 1/4 TS Impedance 1k 

Power Supply: 9V, 100mA DC regulated 
Power Connector: 2mm DC Jack, Negative Center 

Battery: 9v Type 6LR61 
Power Consumption: 30mA 
Dimensions: 4.9”D x 2.76”W x 2.12”H 

Weight approx. 0.33kg (0.73lbs) 
 

SAFETY INSTRUCTIONS 
Do not use near water, or install near heat sources. Use only authorized attachments / accessories. 

Do not service product yourself. Contact our service department with any questions or to schedule 
repair service.