Alesis DG8 User Manual
Chapter 1: Getting Started
DG8 R
EFERENCE
M
ANUAL
27
9. Using the Cursor and the
▲
and
▼
Arrows
When interacting with the display, the sound that is underlined by the
cursor
cursor
is the one that will be affected by the
▲
and
▼
arrows. You can always
keep track of where the cursor is because during normal operation, the last
sound that you select
sound that you select
has the cursor. But if necessary, you can move the
cursor to another active segment of the display by pressing the
PLAY
button.
Repeated pressing of the
PLAY
button moves the cursor among the active
fields in the display. Just keep in mind that you can’t move the cursor to a
blank
blank
field. For example, in a Layer, the cursor will only move between the
PRIMARY
and the
LAYER
sounds. In a Split, the cursor will only move between
the
PRIMARY
and the
SPLIT
sounds. In a Split-with-Layer, the cursor will move
among all three
PRIMARY
,
SPLIT
and
LAYER
sounds.
Tip
: You can perform a quick reset when certain parameters are being displayed.
Pressing the
▲
and
▼
arrows together will reset the following parameters:
SET SPLIT
split point resets to C2
TRANSPOSE
transpose value resets to Middle C
TUNE
Master Tune resets to
00
MIDI
Page 4
:
Keyboard
Scaling
resets to
50
When the display is in its normal mode of displaying selected Sound Programs,
pressing the
pressing the
▲
and
▼
arrows together will reset Keyboard Bank and Bass Bank
programs to “
A
”. Card Bank programs reset to
000
.
U
SING THE
C
ONTROLS
10. Level Controls
Raise or lower the
VOLUME
slider to adjust the output level to a comfortable
listening volume. The
VOLUME
slider adjusts the overall level for everything:
Primary sounds, Layers, Splits and Effects. But you can also use the
LEVEL
sliders to make further adjustments to the sound balance:
•
Adjusting the
LAYER
slider changes the output of the Layer sound
relative to the Primary sound. The output level of the Primary Sound
stays constant when playing a Layer.
stays constant when playing a Layer.
•
Adjusting the
SPLIT
slider changes the output of the Bass Program or the
Card Program assigned to the lower keyboard range relative to the
Primary. The output level of the Primary Sound stays constant when
playing a Split.
Primary. The output level of the Primary Sound stays constant when
playing a Split.
•
Reverb and Chorus have been pre-programmed in nearly all of the
sounds. You can raise or lower the amount of effects with the
sounds. You can raise or lower the amount of effects with the
REVERB
and
CHORUS
sliders.
The exception to this is the
ELECTRIC ORGAN
Bank which substitutes a
rotating speaker effect instead of chorus. The
CHORUS LEVEL
slider acts as
a speed control for the rotating speaker.
•
Remember also that the DG8’s built-in speakers can be turned off by
using the
using the
SPEAKER ON/OFF
switch on the back panel.