Yamaha 007POTO-G0 User Manual
151
LS9-16/32 Owner’s Manual
15
T
alkbac
k / Oscillator
Chapter 15
Talkback / Oscillator
This chapter explains how to use the talkback and oscillator functions.
Talkback is a function that sends the signal of the selected INPUT jack to the desired bus. This is
used mainly to convey directions from the operator to the performers and staff. The LS9 also con-
tains an oscillator that allows a sine wave or pink noise to the desired bus, and this can be used
to check external equipment or to test the response of the room.
The diagram below shows the signal flow of the talkback and oscillator.
used mainly to convey directions from the operator to the performers and staff. The LS9 also con-
tains an oscillator that allows a sine wave or pink noise to the desired bus, and this can be used
to check external equipment or to test the response of the room.
The diagram below shows the signal flow of the talkback and oscillator.
Here’s how a signal received at an INPUT jack 1–16 {1–32} can be output to the desired bus.
1
In the DISPLAY ACCESS section, press the
[MONITOR] button repeatedly to access the
TALKBACK screen.
[MONITOR] button repeatedly to access the
TALKBACK screen.
In the TALKBACK screen you can check the status of
the talkback and turn it on/off.
the talkback and turn it on/off.
1
TALKBACK ON button
This switches talkback on/off.
B
INPUT TO TALKBACK field
Of the INPUT jacks 1–16 {1–32}, the input sensitiv-
ity, input level, and phantom power on/off status of the
jack used for talkback is shown here. You can adjust
the input sensitivity by selecting the GAIN knob in
this field.
ity, input level, and phantom power on/off status of the
jack used for talkback is shown here. You can adjust
the input sensitivity by selecting the GAIN knob in
this field.
●
Input select popup button
This displays the INPUT PORT SELECT popup
window, where you can select the INPUT jack
used for talkback.
window, where you can select the INPUT jack
used for talkback.
●
+48V button
This is an on/off switch for the phantom power
(+48V) supplied to the INPUT jack used for talk-
back.
(+48V) supplied to the INPUT jack used for talk-
back.
●
GAIN knob
This adjusts the input sensitivity of the INPUT
jack used for talkback.
jack used for talkback.
●
Input level meter
This indicates the input level of the mic connected
to the INPUT jack used for talkback.
to the INPUT jack used for talkback.
C
ASSIGN field
This selects the buses to which the talkback signal will
be sent. If you want to clear all selections, move the
cursor to the CLEAR ALL button and press the
[ENTER] key.
be sent. If you want to clear all selections, move the
cursor to the CLEAR ALL button and press the
[ENTER] key.
About talkback and oscillator
TALKBACK
ON
INPUT 1-16{32}
1 2 ...
...
15 16
ST
L R
MATRIX CUE
ON
+48V
AD
[INPUT]
+
-
1
2
3
METER
HA
ON
METER
GAIN/TRIM
[1-16{32}]
INPUT
+48V
+48V MASTER
INPUT
SELEECT
OSCILLATOR
Sine Wave
Pink Noise
Pink Noise
Burst Noise
HPF
LPF
LEVEL
OSC
MIX
M
O
N
O
N
O
(C) 1 2
7 8
L R
Using talkback
1
3
2