Tascam 2488neo User Manual
TASCAM 2488neo
59
7 − Recorder
The track editing functions available on the 2488neo are:
COPY
•
∑
PASTE
COPY FROM
•
∑
TO
COPY
•
∑
INSERT
MOVE
•
∑
PASTE
MOVE
•
∑
INSERT
OPEN
•
CUT
•
SILENCE
•
CLONE TRACK
•
CLEAN OUT
•
See the sections below for details of how to use these functions.
T I P
These operations can be undone (see "UNDO and
REDO" on page 64). For example, even if you have
erased an entire track, you can easily restore it.
REDO" on page 64). For example, even if you have
erased an entire track, you can easily restore it.
Although you cannot use virtual tracks as sources for copy
and move operations, you can assign a virtual track tem-
porarily to a physical track for track editing operations and
then reassign it when you are finished (see
and move operations, you can assign a virtual track tem-
porarily to a physical track for track editing operations and
then reassign it when you are finished (see
Track editing functions
Entering the edit mode
1 Make sure that the 2488neo is stopped (not playing
back or recording).
2 Press the
EDIT TRK
key (below the monitor controls).
3 Use the dial to highlight the track editing function
you will be using and press the
YES/ENTER
key.
4 Select the appropriate values, as described below.
5 Press
YES/ENTER
to perform the operation, or
NO/
EXIT
to exit without performing the operation.
IN, OUT, TO and FROM
The IN, OUT, TO and FROM points are used for editing
operations (the IN and OUT points are also used for the
previously described auto punch and repeat functions).
operations (the IN and OUT points are also used for the
previously described auto punch and repeat functions).
to set and trim (adjust) these points.
The IN point is the start of the section to be edited at the
beginning of track editing.
beginning of track editing.
The OUT point is the end of the section to be edited at the
beginning of track editing.
beginning of track editing.
The TO point is the destination for many editing opera-
tions, including copy and paste, copy and insert, move and
paste, and move and insert.
tions, including copy and paste, copy and insert, move and
paste, and move and insert.
In COPY FROM
∑
TO editing, the FROM point is a
point set within the section to be copied. See “COPY
FROM
FROM
TO” on page 60 for details.
NOTE
If the interval between IN and OUT points is less than
0.5 seconds, the popup screen does not appear and
you cannot use COPY, MOVE or other editing func-
tions. Increase the interval between IN and OUT points
to more than 0.5 seconds to use these functions.
0.5 seconds, the popup screen does not appear and
you cannot use COPY, MOVE or other editing func-
tions. Increase the interval between IN and OUT points
to more than 0.5 seconds to use these functions.