Panasonic AG-HMX100E User Manual

Page of 48
20
Basic Oper
ation
Setting Screen
When setting up this unit or adjusting functions, you need to check the current settings on the LCD screen. 
The following shows the basic configuration of the setting screen.
POS.
MOSAIC
SIZE
OFF
XY
0
OFF
0
DEFOCUS
LEVEL
OFF
MONO
EVENT
VIDEO EFFECTS
CH A
ME TIME
PATTERN
INT
00
 E
2:00
 F
3044 WHT
X  128
Z  196
FAN STOP
Y  128
1
2
3
5
4
6
1  Joystick, rotary Z control settings, and 3D display 
area
Shows the setting values of the joystick and rotary Z 
control; X, Y, and Z values during position setting and 
P
B
, P
R
, and C GAIN values during color setting.
When this unit is in 3D mode ( page Vol. 2-25), [3D] is 
displayed.
2  Audio level meter
Indicates the audio output level.
3  Error Message
An error message appears in the following cases.
Message
Condition and Action
FAN STOP
The fan has stopped from any cause.
Immediately turn off the power and 
request a service call ( page 39).
CHANGE HDMI 
FORMAT
CHANGE HDMI1 
FORMAT
CHANGE HDMI2 
FORMAT
HDMI input source in the format other 
than the system formats ( page 19) 
available for this unit is being 
connected to this unit.
CHANGE HDMI FORMAT:
 Input 
sources of both HDMI IN 
connectors are in unavailable 
formats.
CHANGE HDMI1 FORMAT:
 
Input source of the HDMI IN 1 
connector is in unavailable format.
CHANGE HDMI2 FORMAT:
 
Input source of the HDMI IN 2 
connector is in unavailable format.
Change the system format setting or 
the input source setting.
 NOTE
The “FAN STOP” error message is also displayed on the 
multi-view screen. However, since the multi-view screen 
does not open when this unit is in 3D mode (
 page 
Vol.2-25), no error message is displayed even if the fan 
stops. Pay attention to a message which will appear on the 
LCD.
If two types of errors occur at the same time, “FAN STOP” 
is displayed preferentially.
4  Event number, transition time, pattern number, and 
internal video display area
EVENT:
 Shows the event number ( page Vol.2-20).
ME TIME:
 Shows the setting value of transition time 
( page 35); DSK TIME value during downstream 
key setting ( page 37) and FADE TIME value 
during fade setting ( page 38). 
To change the TIME type, press the applicable 
transition time setting button (ME, DSK, or FADE) to 
turn on.
PATTERN:
 Shows the number of the currently selected 
pattern ( page 35).
INT:
 Shows the type of the currently selected internal 
(internally generated) video ( page 28).
5  Menu title, related information, rotary 1 to 5 
parameter display area
Shows the title of the currently selected menu 
( page 21) (e.g., VIDEO EFFECTS), bus settings 
(A/B), related information (color settings, etc), and 
setting positions of rotary 1 to 5 controls.