Siemens TC12 User Manual
TC12 Installation, Commissioning & Maintenance Handbook
3.3.3
ancel time) (GIQ)
/Queue unit no.:0 to 5}={Queue inactive time.:0 to 255} (0)
ify the time in seconds that a configure queue unit input
active before its output which was p
iously active is
3.3.3
CF)
ctor code.:1 to 8} (5)
h count unit
e number of
eply bit
ange state. The
The va
sed depends on
count s
generally a
e the ma
um flow will be
red.
ata value
Count/Occupancy weighting factor
.17 Queue unit inactive time (C
GIQ{Count/Occupancy
Comment:
To spec
d
must be in
cleared.
cleared.
rev
.18 Count weighting factor (G
GCF
0 to 5
Comment:
The count weighting factor for ea
{Count unit no.:
} = {Count weighting fa
c
is th
internal counts required to cause the r
.
to ch
data is selected using the table below
h
lue u
the maximum vehicle flow rate at eac
weighting factor of approximately twic
weighting factor of approximately twic
ite,
xim
xim
requi
D
1 1
2 2
3 4
4 8
5 16
6 32
7 64
8 128
2 2
3 4
4 8
5 16
6 32
7 64
8 128
3.3.3
cy weighting fac
.:1 to 8} (6)
Comment:
The occupancy weighting factor is the number of internal counts
hange state. The value is
above (see GCF com
nd). The internal
is 25 Hz for 100% occupancy so a w ghting factor of 32
, giving a change of state eve
.28 seconds.
.19 Occupancy weighting factor (GOF)
GOF{Occupancy unit no.:0 to 5} = {Occupan
tor
required to cause the reply bit to c
selected using the table
selected using the table
ma
count rate
ei
is normally used
ry 1
666/HE/43100/000
Page 94
Issue 9