Siemens TC12 User Manual
TC12 Installation, Commissioning & Maintenance Handbook
3.3.3.2 OTU reset (CNN, LRN, TKE)
(3) TKE=?
Comment:
Comment:
eset
n data.
p communication with the Instation
GNO, GCW, GRW
3.3.3.3 OTU addre
GAD={addre
Comment:
3.3.3
baud rate and modem mode.
8 = 600 Baud half duplex
22 = 1200 Baud full duplex
24 = 600 Baud ful
t STC before use:
E
7 = 1200 baud half duplex with equaliser
23 = 1200 baud full duplex with equaliser.
3.3.3.5 Number of OTUs (GNO)
GNO={Number of OTUs on the line: 1 to 15 (1)}
3.3.3.6 Number of control words (GCW)
GCW{OTU Address: 0 to 14}={No. of control words for OTU: 0 to 3 (2)}
Comment: The above command is repeated for each OTU on the telephone
line. For each OTU enter its address and the number of control
words it uses.
words it uses.
3.3.3.7 Number of reply words (GRW)
GRW{OTU Address: 0 to 14}={No. of reply words for OTU: 0 to 14 (4)}
(1) CNN=???
(2) LRN=???
(2) LRN=???
??
The above reset commands may be entered in any order, the r
is actioned by switching the OTU power off for a few seconds then
re-applying power. On restart the default OTU configuration data
will replace all existing configuratio
re-applying power. On restart the default OTU configuration data
will replace all existing configuratio
Commands to set u
GAD, GMM,
ss (GAD)
ss of OTU: 0 to 14
(0)}
Address of the OTU being installed.
.4 Baud rate/Modem mode (GMM)
GMM={Baud rate/mode: 0 to 24
(6)}
Comment:
Code that configures the appropriate
6 = 1200 Baud half duplex
l duplex
Other codes are available, but consul
.g.
5 = 300 baud half or full duplex
666/HE/43100/000
Page 89
Issue 9