GE 131-10595-2 1-07 JR User Manual

1-07 JR

— Save these

instructions for local inspector’s use.

— Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the consumer.

• Note to Consumer – Keep these instructions

for future reference.

• Proper installation is the responsibility of the

installer and product failure due to improper
installation is NOT covered under the warranty.

• NOTE – This appliance must be properly

grounded.

All electric drop-in ranges must be hard wired
(direct wired) into an approved junction box. 
A plug and receptacle is NOT permitted on
these products.

JDS28, JDP39

Junction Box

Wire Nuts

Strain Relief Clamp
for 1/2” conduit

Lower Trim 
2 Screws

2 Shoulder Screws
(for stop device)

1/8” Drill Bit and 
Electric or Hand Drill 

Phillips Screwdriver

Nut Driver

Level

Tape Measure

Straight Edge
or Square

Hand or Sabre Saw

Standard Screwdriver

Pencil

Safety Glasses

Hammer