JVC KM-H2500U User Manual

Press RECALL.

Select the memory register you wish to recall 
from as follows:

• If you are using Bank Mode, select a pattern 

button to designate the memory register in the 
selected bank. You may also use the Bank 
knob to change the selected bank before 
recalling.

• If you are using Direct Access Mode, select a 

pattern button to designate the desired bank 
and then select a second pattern button to 
designate the memory register.

• Recalling a memory register that requires a new 

image to be loaded from a USB drive into a 
Media-Store channel may result in the currently 
loaded image being displayed for a few frames 
while the new image is loaded.

• You can exit without recalling a memory register by 

pressing any button other than a Wipe Pattern, 
dedicated key transition, CUT, AUTO TRANS, or 
source button.

You can choose to have a bus remain unaffected by a 
memory recall (the selected source on the bus is not 
replaced with the source stored in the memory).

Press and hold the desired source button on the 
desired Program, Preset, or Key/Aux bus.

Press RECALL.

Select the memory register you wish to recall 
from as follows:

• If you are using Bank Mode, select a pattern 

button to designate the memory register in the 
selected bank. You may also use the Bank 
knob to change the selected bank before 
storing.

• If you are using Direct Access Mode, select a 

pattern button to designate the desired bank 
and then select a second pattern to designate 
the memory register.

The source on the bus you selected will not 
change when the memory is recalled (the source 
setting stored in the memory for that bus is 
ignored).

The switcher can be set so that recalling a memory 
does not affect what is currently on-air. There are two 
modes you can choose from:

• Recall to Preview — The switcher only recalls 

those elements from the memory register that are 
not currently on-air. Background elements are 
recalled to the Preset bus.

• Memory AI — The switcher uses the contents of 

the memory register to configure the Next 
Transition area and the Preview bus. The switcher 
is configured such that the next transition will make 
the on-air state the same as the state saved in the 
memory register.

Enabling Memory AI mode changes the way key 
elements are recalled. If a key is currently on-air, the 
element for that key is recalled in the next available 
off-air key. If there is no available off-air keys, the 
element is not recalled.

All resource sharing is set to FLOAT mode so that 
key elements may be recalled to other keys than 
originally stored. 

For More Information on...
• Resource sharing, refer to the section “Resource 

Table 4  shows the contents of a memory register and 
the state of the switcher in various scenarios.

Depending on the Recall to Preview setting, the 
elements recalled are as follows:

• Scenario 1

› Input 3 is recalled to the Program bus (on-air 

image instantly cuts to Input 3).

Input 3

Input 1 

(on-air)

Input 1 (on-air)

Input 4

Input 2 

(on-air)

–

Input 5

–

–

–