JVC KM-H2500U User Manual

• You do not need to store memory banks or 

registers to the same memory banks or registers 
on the USB drive.

• If you save an empty memory bank or register, the 

destination bank or register on the USB drive is 
erased.

Once the memory registers are loaded, you can recall 
them for use.

Insert a USB drive into the USB port.

Press MENU.

Press the LOAD Wipe Pattern button.

Press the Mems knob to display the Load 
Memory menu.

Press NEXT to cycle through the sets.

Press the knob for the set you want to load the 
memory registers from.

Use the left knob to select which memory 
registers you wish to load. You can choose from 
the following:

• All — All memory banks and registers are 

replaced with the stored memory banks and 
registers from the selected set on the USB 
drive.

• Bank — You can specify which memory bank 

to load from the USB drive and which memory 
bank on the switcher to replace with the 
loaded values.

• Indiv — You can specify which memory 

register to load from the USB drive and which 
memory register on the switcher to replace 
with the loaded values.

If you selected Indiv or Bank, select the memory 
bank or register to load as follows:

• If you selected Indiv, use the Local knob to 

select the memory register you wish to replace 
with the loaded data. The selected register is 
indicated as X.Y where X is the memory bank 
and Y is the memory register. Use the USB 

knob to select the memory register on the 
USB drive you wish to load.

• If you selected Bank, use the Local knob to 

select the memory bank you wish to replace 
with the loaded data. Use the USB knob to 
select the bank on the USB drive you wish to 
load.

Press the left knob to commit the load.

10. Press the Confrm knob to perform the load. 

Press the Cancel knob to cancel the load.

• You do not need to load memory banks or registers 

on the USB drive to the same memory banks or 
registers on the switcher.

• If you load an empty memory bank or register from 

a USB drive, the destination bank or register on the 
switcher is erased.

For More Information on...
•  using the memory system, refer to the section 

Software upgrades stored on a USB drive can be 
uploaded to the switcher. 

Copy a software upgrade file onto a USB drive. 
Do not store multiple upgrade files on the same 
USB drive.

Insert the USB drive with the software upgrade 
file into the USB port.

Press MENU.

Press the RESET Wipe Pattern button.

Press NEXT until Run Software Upgrade From 
USB is displayed.

Press the left knob.

Press the Confrm knob to initiate an upgrade. 
Press the Cancel knob if you do not wish to 
perform an upgrade.

The menu displays a message indicating the software 
upgrade is in progress. The Upgrade LED on the rear 
of the switcher is lit, indicating an upgrade is in 
progress.