Mackie 1220I User Manual
Quick Start Guide
17
AUX SEND 1-2
A direct copy of the aux send 1 and 2 outputs can
be sent via FireWire to your computer. This makes it
possible to use a software effects processor instead of an
expensive external processor.
possible to use a software effects processor instead of an
expensive external processor.
To setup a software effects processor:
•
Set up an aux send in post mode, by pressing
the post switch in the aux master section.
the post switch in the aux master section.
•
Aux send FireWire outputs 13 and 14 are
available for your computer.
available for your computer.
•
Pass this through your audio production
software running effects plugins.
software running effects plugins.
•
Return the processed output to mixer channels
11 and 12 (input switch set to FW 1-2).
11 and 12 (input switch set to FW 1-2).
•
Alternatively bring the processed sounds into
the control room (engage FW 1-2) and add it to
the main mix (engage assign to main mix).
the control room (engage FW 1-2) and add it to
the main mix (engage assign to main mix).
•
You can even use the computer as two separate
independent mono in, stereo out processors.
Have aux 1 go into one plugin, and aux 2 go into
a different one. The stereo outputs of both
plugins are combined back into the stereo
stream coming back to the mixer. Again,
performance will vary based on system
hardware.
independent mono in, stereo out processors.
Have aux 1 go into one plugin, and aux 2 go into
a different one. The stereo outputs of both
plugins are combined back into the stereo
stream coming back to the mixer. Again,
performance will vary based on system
hardware.
MAIN MIX
The left and right main mix is always available on
FireWire channels 15 and 16 to send to your computer.
For example, you can record the live performance main
mix onto your computer. The output level to your
computer is not affected by the main mix level control.
For example, you can record the live performance main
mix onto your computer. The output level to your
computer is not affected by the main mix level control.
Modifi cations:
The following FireWire modifi cations can be done by
an authorized service center. Authorized service centers
may be found online at:
www.mackie.com/scripts/service_centers/search.asp
Please contact our technical support department if you
are having trouble fi nding an authorized service center
in your area.
may be found online at:
www.mackie.com/scripts/service_centers/search.asp
Please contact our technical support department if you
are having trouble fi nding an authorized service center
in your area.
Post-Insert FireWire Sends
The pre-EQ channel FireWire sends are pre-insert,
but the circuit boards can be modifi ed so that they are
post-insert instead. This allows for the use of an
external processor on the mic signal, sending the result
to the FireWire, while still pre-EQ.
post-insert instead. This allows for the use of an
external processor on the mic signal, sending the result
to the FireWire, while still pre-EQ.
Post-Fader FireWire Sends
The post-EQ channel FireWire sends are pre-fader,
but the circuit boards can be modifi ed so that they are
post-fader instead. This allows the channel fader to
control the level of the FireWire sends from each
channel.
post-fader instead. This allows the channel fader to
control the level of the FireWire sends from each
channel.