Ampeg BA-210SP User Manual
BA-210SP
Bassamp Cube with Digital Effects
SYSTEM BLOCK DIAGRAM:
Preset A
Preset B
Preset C
Preset D
7
The BA-210SP allows you to save four DSP settings by means of the two button footswitch sup-
plied with the amplifier. Use the following steps to store and recall four DSP s e t t i n g s :
plied with the amplifier. Use the following steps to store and recall four DSP s e t t i n g s :
•Press the footswitch button until both LEDs are off – select an effect (bypass, “0”) – for reference,
this shall be Preset A
•Press the #1 button on the footswitch (the #1 LED illuminates and Preset A is stored) - select
another effect (chorus, “1”) and adjust to taste – for reference, this shall be Preset B
•Press the #2 button on the footswitch (the #2 LED illuminates and Preset B is stored) - select
another effect (octawah, “11”) and adjust to taste – for reference, this shall be Preset C
•Press the #1 button on the footswitch again (the #1 LED turns off and Preset B is stored) - select
another effect (SVT, “12”) and adjust to taste – for reference, this shall be Preset D
•Press the #2 button on the footswitch again (both LEDs are off and Preset D is stored) - Preset A
is automatically recalled – without changing the setting of the Effects control. Selection of the
e ffects is now controlled by the footswitch.
NOTE: The footswitch presets will be retained within the amplifier even after turning the amplifier
off, until the above steps are repeated using different effects settings.
off, until the above steps are repeated using different effects settings.
PROGRAMMING THE FOOTSWITCH: